Abstract:The main chemical component of high-silicon iron tailings (HSITs) is SiO2; HSITs also include some oxides such as Al2O3 and CaO. Mechanical activation can reduce the particle size of HSITs and enhance their pozzolanic activity such that they can be used as a type of mineral admixture for cement-based materials (CBMs). This study aims to investigate the mechanical activation (ultrafine grinding) effects of HSITs, including physical and crystallization structure effects. The particle distribution, specific surface area, density, and solubility of HSITs were tested using laser particle size analysis and other routine physical testing methods. Their crystal structures were analyzed using X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), and differential scanning calorimetry-thermogravimetry (DSC-TG). Grinding reduced the particle size of HSIT particles and increased their specific surface area, wherein the minimum D50 was 5.75 μm, the maximum specific surface area was 7608 m2/kg, and the corresponding grinding time was 3.5 h. With an increase in grinding time, the solubility showed an increasing trend; however, the density showed a decreasing trend. The change was fast before 3.5 h or 4 h and then slowed down, but the final solubility was still higher than its initial level, while the final density was still lower than its initial level. Grinding reduced the degree of crystallization of the minerals in HSITs and increased the microscopic strain and disorder of its crystal structure. These changes were significant for a grinding time of 0–3.5 h, after which the changes tended to be slow. The symmetry and integrity of the SiO2 structure decreased with grinding. The activity index of the HSIT powder was higher than 0.6. Ultrafine grinding improves the particle size distribution of HSITs and reduces the crystallinity of their main minerals, which in turn increases their chemical reactivity. It can be said that ultra-finely ground HSIT powder is pozzolanic and can be used as a mineral admixture for CBMs, and its grinding limit can be inferred to be 3.5 h.

Effect of Grinding Media on Surface Property and Flotation Performance of Ilmenite

Effect of Grinding Media on the Flotation Behavior of Fluorite Using Sodium Oleate As a Collector

Effects of grinding media on flotation performance of calcite

Effects and Mechanisms of Grinding Media on the Flotation Behavior of Scheelite

Effects of grinding media on the flotation performance of cassiterite

Influences of grinding parameters on flexural strength in the grinding of Li-spinel ferrites with electroplated diamond wheel

Microscale insights into the influence of grinding media on spodumene micro-flotation using mixed anionic/cationic collectors

Influence of Particle Size on Flotation Separation of Ilmenite and Forsterite

Effects of Grinding Media on Grinding Products and Flotation Performance of Sulfide Ores

Effects of surface Chemistry, particle morphology and pretreatment on zircon flotation

Effect of different particle size fractions on flotation separation of fine rutile from garnet

Effects of Mechanical Grinding on the Physicochemical Properties of Silica Aerogels

Effects of Ball Milling and Ultrasonic Treatment on the UV Shielding Performance of Illite Micro Flakes

Wet Grinding of Montmorillonite and Its Effect on the Properties of Mesoporous Montmorillonite

Ultrafine Grinding of MgTiO3 Based Ceramic Influencing the Material Properties

Enhanced flotation of chalcopyrite particles by grinding with short cylinder media

Influence of Wet Milling Process Parameters on the Zirconium Silicate Average Particle Size

Effect of grinding media properties and stirrer tip speed on the grinding efficiency of a stirred mill

Effect of grinding media on the milling efficiency of a ball mill

Exploring the effect of a polyacrylic acid-based grinding aid on magnetite-quartz flotation separation

On the grinding effects of high-silicon iron tailings