Abstract:In view of the fact that the partial discharge (PD) signal energy is mainly concentrated below hundreds of megahertz, the ultra-high frequency part of the energy is weak, and the interior space of the switchgear is narrow, this paper proposes a new method for PD detection of the switchgear based on near-field detection. Firstly, based on the principle of PD, the field characteristics of the signal in the switchgear are analyzed. After that, the probe is designed with an electric small loop structure. Based on its equivalent circuit, its measurement principle and amplitude frequency characteristics are analyzed. The influence of probe size and material on amplitude frequency characteristics is obtained by using simulation software High Frequency Structure Simulator (HFSS), and the probe parameters suitable for PD detection in the switchgear are determined. Finally, the performance of the probe is measured by network analyzer, and the PD signal is tested on the simulated PD test platform. The results show that the probe works in the frequency band of 10–200 MHz and can receive PD signals containing more energy information. In the operating frequency band, the reflection coefficient of the probe port is very large, and its interference to the signal near field is particularly small. The probe also has good frequency response characteristics, and the fluctuation in the frequency band is less than 5 dB, which can obtain more accurate PD signal characteristics in subsequent processing. In addition, the probe is passive, with dimensions of 166 mm in length, 104 mm in width, and 2 mm in thickness, which is suitable for placing in the switchgear with small internal space. The results of PD receiving test show that the probe can reflect the occurrence of PD remarkably and accurately.

A Partial Discharge Detection Method for Switch Cabinets Based on a Second-Order Circuit

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Partial Discharge Detection Technology for Switchgear Based on Near-Field Detection

Partial Discharge Recognition in Real Switchgear Based on Soft Scoring Mechanism and Multi-Mode Fusion

Partial Discharge Detection in Gas-Insulated Switchgears Using Sensors Integrated with UHF and Optical Sensing Methods

Experimental Investigation of Partial Discharge Detection in Medium-Voltage Switchgear Based on Ultra-High-Frequency Sensor

Comprehensive Detection of Partial Discharge in Switchgear Using TEV

Partial Discharge Monitoring on Metal-Enclosed Switchgear with Distributed Non-Contact Sensors.

Research on Partial Discharge Detection of Switchgear Based on Ultrasonic Signal Characteristic

Implementation of A Novel Double-Side Technique for Partial Discharge Detection and Location in Covered Conductor Overhead Distribution Networks

Partial discharge detection, diagnosis, and location technology based on a novel transient earth voltage-ultrasonic integrated sensor used for switchgear equipment

A Technique to Identify the Types of Partial Discharges

Online Monitoring of Partial Discharge in High Voltage Switchgear Using a Differential Electric Field Sensor

Partial discharge detection on power equipment using a magneto-resistive sensor

Experimental Investigation of Transient Earth Voltage and Acoustic Emission Measurements of Partial Discharge Signals in Medium-Voltage Switchgears

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

The Research on Location Method of Partial Discharge in High Voltage Switchgear based on TEV Sensors and TOA Algorithm

Partial Discharge Diagnostics: Data Cleaning and Feature Extraction

The Study on a New Method for Detecting Corona Discharge in Gas Insulated Switchgear

Detection and Identification Technologies of Wide Band Partial Discharge

Passive Wireless Partial Discharge Sensors with Multiple Resonances