Abstract:Summary form only given. The utilization of two-electrode gas spark switch is quite prevalent in pulsed power equipment as an energy controller. Its simple structure, high reliability, and long lifetime make it a relatively appropriate method applied in unconventional situations. This study concerns a two-electrode gas switch in a small airtight chamber under repetitive working condition without triggering. It is generally accepted that self-breakdown voltage is a significant index to measure the performance or lifetime of a switch. Admittedly, when the effects caused by arc are subordinate, such as the discharge current is small, merely adopting the models based on voltage or current characteristics could be accurate. However, when other factors play more important roles during the discharge process, the electrical parameters might be inadequate to describe the mechanisms. In order to gain a deeper understanding of the mechanisms in this unconventional switch, some optical diagnoses were introduced, including light emission and spectroscopy. In previous studies on this topic, it has been found that during the several thousand shots of the switch, arc's thermal effects, decomposition of insulation materials, and electrode erosion are all crucial to the switch's performance. Except the electrical parameters and chemical analyses, more immediate methods for the dynamic discharge process seem essential. Therefore, the light emitted by the arc plasma channel should be investigated, which reveals different kinds of information. In this study, photomultipliers (PMTs) and a spectrograph (AvaSpec-2048) were utilized to detect the light emission from the arc. The discharge pulsed current is peaking at approximately 60 kA and lasting about 70 μs. The spectrum demonstrates that more spectral lines appear when there are more shots, including some unexpected lines. The results are in accordant with the previous experimental data and could be used to explain how the decomposition of insulation materials and electrode erosion influence the breakdown process and lead to abnormal discharges.

Research on Electro-Thermal-optical Characteristics of Abnormal Glowing Contact of Electrical Lines

Glowing Contact in Electrical Fires: Experimental Investigation and Modeling on Its Heat Intensity and Thermal Hazards

Microstructure and Component Analysis of Glowing Contacts in Electrical Fire Investigation

Dynamic variation characteristics of glowing contact resistance

Experimental study on the DC discharge characteristics of wire-to-cylinder electrode configuration at high temperature

Experimental Investigation of Electrical Performance of AgCdO Contact Material under Switching Capacitive Load Conditions

Experimental Study of the Vacuum Arc Motion-Diffuse Transition in Cup-Shaped Transverse Magnetic Field Contacts

Experimental research on the fault arc arcing process and electrode temperature distribution of a 220VAC power system

Experiment Investigation on Triggered Vacuum Arc under the Different Contact Materials

Study on the Mechanism of Arc Transition from Metallic Phase to Gaseous Phase

Experimental investigation on "glow flow" phenomenon during current-zero period between transverse magnetic contacts

Investigation of vacuum arc ignition characteristics and erosion morphology microstructure characteristics of CuCr55 electrode contact materials

Experimental Study of Ignition Process Caused by Poor Electrical Contact of Connecter

Researches on Spectrums and Macroscopic Forms of DC Arc in a Short Air Gap

Influence of electrode contacts on flashover characteristics of alumina and PTFE under pulsed voltage in vacuum

Light Emission And Spectroscopy Characteristics Of An Unconventional Gas Spark Switch

Experimental Investigation on Anode Spots and Anode Plumes in High-Current Vacuum Arc under Different Contact Materials

Experimental Research on the Thermal Characteristic of Low-Voltage Alternating Current (AC) Arc Faults

Experimental Study and Characteristic Analysis of Vacuum Arc Between Cup-Type Axial Magnetic Contacts under Different Diameter-to-gap Ratios

Optical Emission Characteristics of Electrical Explosion of Different Wires in Air

Analysis and Optimization of Contact Material Ablation under the Cumulative Effect of the Number of Breakings of OLTC