A highly utilized and practical lithium-sulfur cathode enabled in all-solid-state batteries

Ashley Cronk,Xiaowei Wang,Jin An Sam Oh,Shuang Bai,Phillip Ridley,Mehdi Chouchane,Chen-Jui Huang,Grayson Deysher,Hedi Yang,Baharak Sayahpour,Marta Vicencio,Choonghyeon Lee,Dongchan Lee,Min-Sang Song,Jihyun Jang,Jeong Beom Lee,Y. Shirley Meng,So-Yeon Ham,Diyi Cheng

DOI: https://doi.org/10.26434/chemrxiv-2024-hj829

2024-08-12

Abstract:All-solid-state batteries (ASSB) using lithium-sulfur (Li-S) cathodes, present a low-cost energy storage solution that can achieve energy densities exceeding 500 Wh kg-1. However, their development in ASSBs has been hindered by poor kinetics, insulative interfaces, and (chemo)mechanical degradation, resulting in low utilization and cycle life. Here, we manipulate the meta-stability and redox activity of sulfide solid electrolytes to form ionically conductive interphases on the cathode surface using a simple and scalable synthesis approach. This creates a microstructure that enables high utilization and reversible electrochemical behavior with both sulfur and Li2S. Bulk and morphological characterization with X-ray absorption spectroscopy quantification is used to validate reversibility. Additionally, optimizing the cathode/catholyte microstructure by tailoring particle size to the micron-scale enhances rate performance for practical operation. The coupled (chemo)mechanical behavior of Li-S cathodes and sulfide solid electrolytes was found to alleviate internal stresses with cycling, especially when paired with high capacity anodes like silicon. As a result, this approach enables high loading sulfur cathodes up to 11 mAh cm-2 with stable operation at room temperature. Several high energy density cell architectures are demonstrated, particularly a Li2S anode-free pouch cell at 4.5 mAh cm-2 that can operate under low stack pressures. This work establishes new design strategies for Li-S cathodes, providing a pathway to enable high energy density batteries for a wide range of future applications.

Chemistry

What problem does this paper attempt to address?

The paper primarily focuses on addressing some key issues of the lithium-sulfur (Li-S) cathode in all-solid-state batteries (ASSBs) to achieve high energy density and low-cost energy storage solutions. Specifically, the research aims to solve the following core problems:

1. **Slow kinetics**: The kinetic process of the Li-S cathode in all-solid-state batteries is relatively slow, which limits its charge-discharge rate and energy utilization efficiency.

2. **Insulating interface**: Due to sulfur being an insulator, the poor contact between the Li-S cathode and the solid electrolyte leads to hindered ion transport.

3. **(Chemical) mechanical degradation**: The Li-S cathode undergoes volume changes during cycling, causing internal stress accumulation, which leads to structural degradation and performance decline.

To overcome the above challenges, the authors adopted a simple and scalable synthesis method to regulate the metastability and redox activity of the sulfide solid electrolyte, thereby forming an intermediate layer with high ionic conductivity on the cathode surface. Additionally, by optimizing the microstructure of the cathode/electrolyte and adjusting the particle size to the micron level, the rate performance under practical operating conditions can be improved. The study also explored the (chemical) mechanical behavior of the coupling between the Li-S cathode and the sulfide solid electrolyte, finding that this method can alleviate internal stress, especially when used in conjunction with high-capacity anodes such as silicon.

Ultimately, the study achieved a high-loading sulfur cathode that operates stably at room temperature and demonstrated several high-energy-density battery architectures, including a pouch cell without the need for a Li2S anode, capable of operating under lower stacking pressure. These results provide new design strategies for developing practical and high-energy-density all-solid-state lithium-sulfur batteries.