Abstract:The thermal stability of the dual phase AlCrFeCoNiCu 0.5 high entropy alloy thin films at up to 600 °C under vacuum was studied through detailed characterization. The evolution of microstructure and chemical composition was revealed by X-ray diffraction, transmission Kikuchi diffraction and transmission electron microscopy . Also, the mechanical properties were measured by nanoindentation . Although the crystalline phase of all the HEA thin films was BCC-dominated, the FCC phase fraction increased from 16.6% (as-deposited) to 28.1% (600 °C-annealed). The as-deposited films exhibited a columnar morphology with an average grain size of 106.1 nm for length and 31.3 nm for width and remained the columnar shape until 600 °C. The columnar grains showed an increasing tendency of size at 200 °C (221.3 nm and 45.6 nm for length and width) and 400 °C (283.9 nm and 56.2 nm). At 600 °C, the columnar grain size decreased to 211.8 nm in length and 59.3 nm in width. Concurrently, the occurrence of new equiaxed grains was observed with an average diameter of 42.4 nm. The reduction of columnar grain size and the formation of equiaxed grains at 600 °C were explained based on the energy dispersive spectroscopy. Although no preferential evaporation was found, the elemental distribution revealed the formation of two secondary phases, i.e., Cu-rich FCC phase and Cr-rich BCC phase. The nanoindentation results indicated that the mechanical properties increased as the increase of annealing temperature. The hardness and elastic modulus of 600 °C-annealed sample were 8.5 ± 0.3 GPa and 205.4 ± 3.5 GPa, respectively, which were 10.4% and 41.5% higher than those of the as-deposited thin film. These findings are critical for a fundamental understanding of the microstructure and properties change of the dual-phase HEA thin films in high working temperatures.

Effect of Annealing on Microstructure, Mechanical Properties and Thermal Conductivity of (Ni5al2)100-Xfex (x = 35, 40, 45 and 50) Eutectic Medium Entropy Alloys

Microstructural Evolution and Elevated-Temperature Strengthening Mechanism of Co-free FeCrMnNiV0.2Alx High-Entropy Alloys During Annealing

Abnormal Annealing-Induced Strengthening in Ni39.3Al15.7Fe45 Eutectic Medium Entropy Alloy

Enhancing the Strength of AlCrFeNi HEAs Via Tailoring Aluminum Content and Optimal Aging Treatment

Effect of Annealing on Microstructure Evolution and Tensile Behavior of Hot-Rolled FeMnCoCrAl High-Entropy Alloy

Microstructure Evolution and Mechanical Properties of NiAlCrFeMo High Entropy Superalloy after Different Annealing Treatment

Effect of annealing temperature on the structure and properties of FeCoCrNiMo high-entropy alloy

Effect of annealing on mechanical and thermoelectric properties of a Al2CoCrFeNi high-entropy alloy

Effect of annealing treatment on microstructural evolution and compressive behavior of Al0.5CrFeNi2.5Si0.25 high-entropy alloy

The microstructural evolution of dual phase high entropy alloy thin films by annealing

Effect of annealing on microstructure and mechanical properties of AlCrFe2Ni2 medium entropy alloy fabricated by laser powder bed fusion additive manufacturing

Effects of Annealing Temperature on the Microstructure and Mechanical Properties of the As-Cast Dual-Phased CoCuFeMnNi High Entropy Alloys Fabricated by Vacuum Induction Melting Method

Effects of Annealing on the Microstructure and Magnetic Property of the Mechanically Alloyed FeSiBAlNiM (m=co, Cu, Ag) Amorphous High Entropy Alloys

Microstructure and mechanical properties of AlCoCrFeNi2.1 eutectic high-entropy alloy synthesized by spark plasma sintering of gas-atomized powder

Effects of cold rolling and annealing treatment on microstructure and properties of CoFeNiMnV high‐entropy alloys

Studying the Effect of Cold Rolling and Heat Treatment on the Microstructure and Mechanical Properties of the Fe36Mn20Ni20Cr16Al5Si3 High Entropy Alloy

The phase stability at intermediate-temperature and mechanical behavior of the dual-phase AlCoCr0.5FexNi2.5 high entropy alloys

Influence of annealing temperatures on the microstructure and deformation behavior of a CrCoNi based medium-entropy alloy

The Effect of Heat Treatment on the Microstructure and Mechanical Properties of Al0.6CoFeNi2V0.5 High Entropy Alloy

Thermal modification of brittle CoFeNi2(Ti3Si5)0.16 eutectic high-entropy alloy by annealing treatment

The Effects of Heat Treatment on the Microstructure and Mechanical Properties of a Selective Laser Melted AlCoFeNi Medium-Entropy Alloy