Abstract:This paper investigates the characteristics of selective catalytic reduction (SCR) with a V2O5-WO3/TiO2 catalyst by studying the key parameters and determining a method for controlling ammonia injection with a sample test bench. Four parameters are defined and adopted to represent the characteristics of nitrogen oxides (NOx) and the ammonia reaction. The effects of NH3/NOx ratio (NSR), catalyst temperature, and ammonia injection period on NOx conversion efficiency and ammonia slip are investigated. The correlation between ammonia slip and ammonia saturation storage level is studied. The experimental results show that the ammonia saturation storage level has a great impact on NOx reduction and ammonia slip. The NOx conversion efficiency and ammonia slip strongly depend on the ammonia saturation storage level. Under such conditions, the NOx conversion efficiency is best when the ammonia saturation storage level is 68.2~73%, and the value reaches 75% before ammonia slip. Pulse injection improves the NOx conversion efficiency and limits ammonia slip. Comprehensive comparison shows that the injected ratio of NH3/NOx is first larger and then smaller than is beneficial for the rapid improvement of NOx conversion efficiency; the appropriate NH3/NOx ratio and continuous injection time must be controlled, or it is easy to cause ammonia slip. Therefore, a control algorithm based on ammonia storage saturation level has been proposed. According to the difference between the actual value of ammonia storage saturation and the target value, the controller corrects the injection of urea to achieve control of ammonia storage saturation level. The period of pulse injection has little influence on the mean value of NOx at the outlet; however, it affects the peak level of NOx and ammonia slip. Using varied period pulse injection further improves the NOx conversion efficiency and restrains ammonia slip. The outlet level of NOx can be reduced by adopting a suitable ammonia pulse injection interval.

Model-Based NH3 Slip Detection for SCR + ASC System Control and OBD

Robust, Model-Based Urea Dosing Control for SCR Aftertreatment Systems using a Cross-Sensitive Tailpipe NOx Sensor

Model Predictive Control Case Study: Selective Catalytic Reduction (scr) System in Coal-Fired Power Plant

Robust Nonlinear Disturbance Observer Design for Estimation of Ammonia Storage Ratio in Selective Catalytic Reduction Systems

Model-based NH3 Adaptation Method for SCR Control

Ammonia storage and slip under steady and transient state in close-coupled SCR

Data-Based On-Board Diagnostics for Diesel Engine NOx-Reduction Aftertreatment Systems

Ammonia coverage ratio control of a novel two-cell SCR-DeNOX system configuration based on IA-ISMC

Prediction and Control of the Nitrogen Oxides Emission for Environmental Protection Goal Based on Data-Driven Model in the SCR De-Nox System

Experimental demonstration of NOx reduction and ammonia slip for diesel engine SCR system

Research on cross sensitivity of NOx sensor and Adblue injection volume in accordance with the actual situation based on cubature Kalman filter

Luenberger-Sliding Mode Observer Based Backstepping Control for the SCR System in a Diesel Engine

Closed-Loop Control Strategy and State Estimator for Diesel Engine SCR After-Treatment System

Model-based urea injection control strategy and ammonia storage estimation for diesel engine SCR system

Design and Development of an Ammonia Slip Detection Device and System for Flue Gas Denitration Equipment

Potential Risk of NH3 Slip Arisen from Catalytic Inactive Site in Selective Catalytic Reduction of NOx with Metal-Free Carbon Catalysts

A temporal discretization and spatial integration SCR model with dual temperature-related parameters

Estimation of Ammonia Storage Nonuniformity for Urea-Based Selective Catalytic Reduction Systems

Model-based fault detecting strategy of urea-selective catalytic reduction (SCR) for diesel vehicles

Design of extended Kalman filter observer coupled to ammonia cross-sensitivity model for an SCR system

Investigation and Control Technology on Excessive Ammonia-Slipping in Coal-Fired Plants