Abstract:This work involved the synthesis of compositions of Ba 0.95 Ca 0.05 Sn x Ti 1-x O 3 (BCST) with varying amounts of Sn dopant (x = 0, 0.02, 0.04, 0.06, 0.08, and 0.1). A standard solid-state reaction approach was used to create all of the ceramic compounds. Each BCST composite's microstructure, sintering, morphology, density, optical, and electrical characteristics were carefully examined, and the dielectric performance was optimized. In comparison to the unmodified composite, introducing varied amounts of Sn material into the BCST compound changed the crystal lattice vibrations and functional group locations. This result indicates that there are some variations in unit cell size, revealing that Sn +4 ions diffused effectively inside the lattice structure to produce BSCT composites. Further, SEM micrographs indicated proportionate changes in the homogenous structure and irregular forms as Sn concentration increased, as well as some variation in average grain size. As a consequence, by adding 0.08 mol% of Sn dopant, the crystallite size and average grain size were adjusted to 45.69 nm and 0.66 μm, respectively. Meanwhile, the 0.08-Sn specimen displayed a dielectric constant (Ɛ) with an optimum value of 5557 and a relative decrease in the Curie-Weiss constant. These results are attributed to the existence of various concentrations of Sn ions at the Ti-site of the BCT, which resulted in a compositionally disordered state. This disordered condition is essential for the production of dielectric compounds. Therefore, it is evident that modifying the amount of Sn doping added significantly enhanced the dielectric characteristics of the BCST composites created in this work. However, excessive Sn doping reduces the dielectric properties due to a reduction in tetragonal phase and an increase of disorders and charge fluctuations.

Transport Properties of Highly Dense Proton-Conducting BaSn 1 _ X in X O 3 _ Δ Ceramics

Transport Properties of Highly Dense Proton-Conducting BaSn1−xInxO3−δ Ceramics

EFFECT OF Nb2O5 DOPING ON DIELECTRIC PROPERTIES OF BaTi0.9Sn0.1O3 CERAMICS

Improving Energy Storage Performance of Barium Titanate-Based Ceramics by Doping MnO2

Protonic Conduction in the BaNdInO 4 Structure Achieved by Acceptor Doping

Defect Dipoles Induced High‐energy Storage Density in Mn‐doped BST Ceramics Prepared by Spark Plasma Sintering

Doping Effects In (Ba0.85ca0.15)(Hf0.1ti0.9)O-3 Lead-Free Piezoelectric Ceramics Prepared Via Powder Injection Moulding Using Simple Binder

Ca/Sn concentration-dependent enhancement of barium titanate ferroelectric performance: a dielectric and microstructural study

Influence of ZnO Additive on the Properties of Y-doped BaSnO3 Proton Conductor

Why Sn Doping Significantly Enhances the Dielectric Properties of Ba(Ti 1-X Snx)O3.

Synthesis, Structure and Protonic Conduction of Basn0.875m0.125o3-Delta (M = Sc, Y, in and Gd)

The effects of 4% barium doping on the morphological, strutural and dielectric characteristics of (Na0.5 Bi0.5)[(Ti0.8 Zr0.2)0.9(Nb2/3 Zn1/3)0.1]O3

Localization of CuO, NiO, and Co3O4 sintering additives in dense proton-conducting perovskite ceramics based on BaSnO3

Simultaneous Hetero- and Isovalent Doping as the Strategy for Improving Transport Properties of Proton Conductors Based on BaLaInO4

Protonic conductor Lu–doped BaSnO3: Lutetium solubility, electrical properties and H/D effects

Effects of Ba Doping on the Phase Transition of Sr3Sn2O7

Effects of Sn substitution on structural and electrical properties of BaSn0.75M0.25O3-δ (M = Sc, In, Y, Gd, Nd⋯)

Fabrication and Ferroelectric Properties of Ba-Doped Strontium Bismuth Titanate Ceramics

Samarium and Yttrium Codoped BaCeO3 Proton Conductor with Improved Sinterability and Higher Electrical Conductivity

Investigation of electrical conductivity and oxygen relaxation behavior for BaBi0.98Sr0.02Nb5-xTixO15-δ ceramics

Charge Compensation in Zno-Ln(2)O(3) Co-Doped Barium Zirconate Titanate Ceramics