Abstract:Understanding the physical process such as fuel film formation during cold start is essential to reduce engine emissions. In this study, an improved spray-wall impingement model was applied to the cold-start simulation of a diesel engine. The fuel film and emissions formations during cold start were studied in depth. The effects of injection strategies were investigated by the use of various designed injection schemes. The results showed that a certain amount of fuel film is deposited on the wall surface due to the poor spray evaporation caused by the adverse thermal atmosphere in the cylinder. The low combustion temperature, insufficient oxygen, and the deposited fuel film are the primary causes for high HC, CO and soot emissions. The NOx emissions are relatively low because of low combustion temperature and oxygen content. A double injection strategy can reduce the deposited and remaining fuel film by 13% due to improved mixing, which benefits the reduction of HC and CO emissions, while it has a negligible effect on NOx and soot emissions. The percentage of first injected fuel has little impact on the amount of the remaining fuel film and emissions in the studied range. Increasing engine speed can inhibit the formations of fuel film, HC, CO, and soot emissions, which is due to the improved fuel evaporation, better flow motion, and thermal environment in the cylinder. Double injection allows a smaller amount of injected fuel to obtain a stable ignition. Decreasing the injected fuel mass can suppress the formation of fuel film and improve mixing, thus reducing HC, CO, and soot emissions. This work expands the application scenarios of the newly developed spray-wall impingement model. The new model has been successfully applied to investigate the cold start process of diesel engines in detail. The results provide insights into the fuel film formation and its effect on emissions, which can guide the development of a cold-start emission control strategy.

Experimental Analysis on the Combustion Performance of Aftertreatment Diesel Burner under Cold Start and Warm-Up Conditions

An Assessment of the Application of Catalyst Preheating Prior to Engine Cold Start to Improve the Filtration Performance of CDPF on Particulate Emissions

Study on Burner Type Diesel Particulate Filter System Using Compressed Air from Turbocharger

Cold and Warm Start Characteristics using HVO and RME Blends in a V6 Diesel Engine

Exhaust Emission Characteristics of Heavy Duty Diesel Engine During Cold and Warm Start

Reducing Cold Start Emissions from Automotive Diesel Engine at Cold Ambient Temperatures

Inlet Exhaust Gas Temperature Condition for a Burner-type DPF at the Low and Moderate Load Steady State

The Optical Investigation on Initial Flame Developing Characteristics of Diesel Jet under Cold Start Conditions

Effect of the Air Flow on the Combustion Process and Preheating Effect of the Intake Manifold Burner

Burner based thermal management approach utilizing in-exhaust burner technology with a CDA equipped engine

Study on Fuel-air Matching Forms in Burner-type Diesel Particulate Filter

Experimental investigation of atomization characteristics at low temperature environments during diesel engine cold start

Analysis of Temperature and Pressure Characteristics in Catalyzed Diesel Particulate Filter Operation for Heavy-Duty Diesel Engine

Environment-adaptive Method to Control Intake Preheating for Diesel Engines at Cold-Start Conditions

Study on Characteristics and Control Strategy of Diesel Particulate Filters Based on Engine Bench

Optimum control on fuel injection and air supply for burner-type diesel particulate filter regeneration

Effect of Injection Pressure on Low-Temperature Fuel Atomization Characteristics of Diesel Engines under Cold Start Conditions

Ignition-Characteristic Research of the Diesel Fuel in Combustion Vessel Simulated Diesel Engine Cold Start Condition

A Numerical Study on Fuel Film and Emissions Formations During Cold Start in a Diesel Engine Using an Improved Spray-Wall Impingement Model

Investigations on the Soot Combustion Performance Enhancement of an Improved Catalytic Gasoline Particulate Filter Regeneration System under Different Electric Heating Powers

Combustion and Emissions of A Direct-Injection Diesel Engine During Cold Start under Different Exhaust Valve Closing Timing Conditions