A Flow-Through Ti4O7 Membrane Electrode for Ballast Water Treatment: Performance, Mechanism, and Comparison with Ti/RuO2-IrO2 Electrode

Yunshu Zhang,Jiaqi Guo,Jing Ding,Cong Li,Qingliang Zhao

DOI: https://doi.org/10.1016/j.seppur.2024.128302

IF: 8.6

2024-01-01

Separation and Purification Technology

Abstract:Electrochemical Advanced Oxidation Processes (EAOPs) present a promising solution for ballast water treatment. However, due to the extremely short half-life of reactive oxygen species, the disinfection active zone is limited to the surface of the electrode, resulting in low disinfection current efficiency of EAOPs. To address this challenge, this study developed a flow-through electrochemical disinfection system utilizing a Ti4O7 membrane electrode. A comparative analysis was conducted against a conventional Ti/RuO2-IrO2 electrode to assess the Ti4O7 membrane electrode's efficacy in ballast water disinfection. The flow-through mode significantly increased the probability of contact between E. coli and the surface of Ti4O7 membrane electrode, consequently leading to a notable increase in the inactivation rate from 1.05 min(-1) to 1.63 min(-1), at a current density of 20 mA/cm(2), at a Cl- concentration of 16.5 g/L, and an initial E. coli concentration of 107 CFU/mL. Notably, at low current densities, the Ti4O7 membrane electrode exhibited superior disinfection performance compared to the Ti/RuO2-IrO2 electrode. The predominant disinfection active species in the Ti4O7 membrane electrode system were identified as reactive oxygen species, particularly center dot OH and center dot O2-, contrasting with the abundant generation of active chlorine species (ACSs) observed in the Ti/RuO2-IrO2 electrode system. Both electrode systems demonstrated the ability to disrupt the cellular structure of E. coli. However, due to the sustained effectiveness of ACSs, the degradation rate of total protein in the Ti/RuO2-IrO2 electrode system (40.53 %) surpassed that of the Ti4O7 membrane electrode system (12.39 %). Despite the minimal concentration of ACSs in the Ti4O7 membrane system (0.02 mg/L), no bacterial regeneration was observed, highlighting the efficacy of the Ti4O7 membrane electrode in preventing bacterial regrowth. This study elucidated a free radical-based disinfection mechanism for the Ti4O7 membrane electrode, affirming its feasibility for ballast water disinfection purposes.