Electrochemical oxidation of reverse osmosis concentrates using macroporous Ti-ENTA/SnO2-Sb flow-through anode: Degradation performance, energy efficiency and toxicity assessment

Min Chen,Xin Zhao,Can Wang,Shuang Pan,Cong Zhang,Yingcai Wang
DOI: https://doi.org/10.1016/j.jhazmat.2020.123295
IF: 13.6
2021-01-01
Journal of Hazardous Materials
Abstract:<p>Due to poor mass transfer performance and high energy consumption of the traditional electrochemical flow-by mode, this study developed a high-efficiency electrochemical oxidation system in flow-through mode based on three-dimensional macroporous enhanced TiO<sub>2</sub> nanotube array/SnO<sub>2</sub>-Sb (MP-Ti-ENTA/SnO<sub>2</sub>-Sb) anode. The effects of initial pH, current density and flow rate on the COD degradation of reverse osmosis concentrates (ROCs) from reclaimed wastewater plant were investigated. Besides, the energy efficiency, biodegradability and acute biotoxicity were studied during electrochemical flow-through process. Compared with the flow-by mode, the flow-through mode based on the MP-Ti-ENTA/SnO<sub>2</sub>-Sb anode had a COD removal rate of 0.38 mg min<sup>−1</sup> (current density: 5 mA cm<sup>-2</sup>) and an electrical efficiency per order (EE/O) of 5.3 kW h m<sup>-3</sup>. The three-dimensional fluorescence spectrum showed that the fulvic acids, humic acids and soluble microbial metabolites of ROCs could be effectively removed by the flow-through anode. In addition, the luminescence inhibition rate of the effluent was 22.4 %, indicating that the acute biotoxicity was reduced by more than 40 %. The electrochemical flow-through process of ROCs treatment required relatively low energy consumption without extra chemical agent addition, showing a broader application prospect.</p>
environmental sciences,engineering, environmental
What problem does this paper attempt to address?
This paper aims to solve several key problems in the treatment of Reverse Osmosis Concentrates (ROCs): 1. **Improve treatment efficiency**: The traditional electrochemical flow - by mode has problems of poor mass transfer performance and high energy consumption. The paper has developed an efficient electrochemical oxidation system based on a three - dimensional macroporous enhanced titanium dioxide nanotube array / tin oxide - antimony (MP - Ti - ENTA/SnO₂ - Sb) anode, using the flow - through mode to improve the treatment efficiency of ROCs. 2. **Reduce energy consumption**: By optimizing the operating conditions (such as initial pH value, current density and flow rate), the degradation performance of chemical oxygen demand (COD) in ROCs, energy efficiency, biodegradability and acute biotoxicity under different conditions were studied. The results show that compared with the flow - by mode, the COD removal rate in the flow - through mode is higher and the energy consumption is lower. 3. **Reduce acute biotoxicity and dissolved organic matter**: It was found that the flow - through mode can effectively remove the acute biotoxicity and dissolved organic matter in ROCs, reducing the environmental risk. Specifically, the paper solves the above problems through the following aspects of research: - **Material preparation**: A three - dimensional macroporous anode (MP - Ti - ENTA/SnO₂ - Sb) with excellent electrochemical properties was prepared, and its structure and properties were verified by a variety of characterization methods. - **Experimental design**: Two reactors, the flow - by mode and the flow - through mode, were designed, and their performance differences in treating ROCs were compared. - **Performance evaluation**: The effects of different operating conditions (such as initial pH value, current density and flow rate) on the treatment effect of ROCs were evaluated, including COD removal rate, energy efficiency, biodegradability and acute biotoxicity. - **Mechanism analysis**: Through fluorescence spectroscopy and linear sweep voltammetry and other methods, the generation mechanism of hydroxyl radical (HO·) in the flow - through mode and its contribution to the degradation of organic pollutants were explored. In conclusion, this paper solves the problems of inefficiency and high energy consumption in ROCs treatment by developing an efficient electrochemical flow - through mode anode, and significantly reduces the potential harm of the treated ROCs to the environment.