Abstract:In this study, the mechanical properties and microstructural evolution of the pre-strained titanium alloy Ti-6Al4V under high-density pulsed electric current (HDPEC) treatment were investigated. The results showed that the HDPEC treatment successfully restored the plastic deformation or strain hardening of the pre-strained Ti-6Al-4V without deteriorating its strength. In addition, multi-HDPEC treatments were conducted to examine the cumulative effect on plastic recovery, and ultrahigh deformability with an increasing rate of 287% was achieved at a current density of 250 A/mm2 for 20 ms. Microstructural characterization indicated that dislocations and the associated sub-grain boundaries were remarkably reduced after the HDPEC treatment, contributing to ductility enhancement. Additionally, the rapidly heat-treated sample with a thermal history curve similar to that of the HDPEC-treated samples did not show obvious microstructural changes, indicating that the athermal effect of the HDPEC treatment plays an important role in modifying the microstructure of the material. The alpha'/alpha" martensite phases were formed in the beta phase after the HDPEC treatment, which is possibly related to the high cooling rate and diffusion of the V element (beta phase stabilizer element). Specifically, at the current condition of 250 A/mm2 for 20 ms, some tiny martensite phases precipitated in the beta phase without heavily deteriorating the microstructure and mechanical properties. Therefore, owing to its low cost and high efficiency, the HDPEC treatment can be applied to Ti-alloy components with internal plastic deformation to realize rapid restoration or achieve long service periods without significantly altering the microstructure.

Accelerated Precipitation and Enhanced Mechanical Properties of Cu-3.5Ti Alloy Via Electropulsing Treatment

Simultaneously enhancing the strength and ductility of Cu-Ti-Fe alloy through electric current pulse induced precipitation

Microstructural Modification and Mechanical Improvement of Ultrafine-Grained Ti Alloy Through Electron Wind Force: an Innovative Approach

Ultrahigh Deformability of Ti-6Al-4V Assisted by High-Density Pulsed Electric Current Treatment

Enhancement of Ductility, Weakening of Anisotropy Behavior and Local Recrystallization in Cold-Rolled Ti-6Al-4V Alloy Strips by High-Density Electropulsing Treatment

Improved Ductility of Aged Mg-9Al-1Zn Alloy Strip by Electropulsing Treatment

A shortened process of tri-modal microstructure developing in Ti-6Al-4V alloy via electropulsing-induces grain spheroidization

Accelerated solid solution and aging induced by electropulsing in Mg-Al-Ca-Mn alloy

Retracted: Effect of High‐Energy Electropulsing on the Phase Transition and Mechanical Properties of Two‐Phase Titanium Alloy Strips

Effect of Electropulsing Treatment on Microstructure and Mechanical Properties of Intermetallic Al3ti Alloy

Improvement of Mechanical Properties of Titanium Alloy by High-Density Pulsed Electric Current

Effect of Electropulsing Treatment on Solid Solution Behavior of an Aged Mg Alloy AZ61 Strip

A Novel Electropulsing Treatment to Improve the Surface Strength and Repair the Pore of Additively Manufactured Ti-6Al-4V Alloy

Mechanism of an acceleration in T1 precipitation kinetics in an Al-Cu-Li alloy by electropulsing

Optimizing strength and ductility in 7150 Al alloys via rapid electropulsing cyclic heat treatment

Accelerating heterogeneous nucleation to increase hardness and electrical conductivity by deformation prior to ageing for Cu-4 at.% Ti alloy

Enhanced α → β phase transition of Ti–6Al–2Zr–1Mo–1V alloy by the electropulsing

Retracted: Effects of High-Energy Electro-Pulsing Treatment on Microstructure, Mechanical Properties and Corrosion Behavior of Ti-6al-4v Alloy (retracted Article. See Vol.90, Pg.781, 2018)

Effect of Electropulsing Treatment on Microstructure and Tensile Fracture Behavior of Aged Mg–9Al–1Zn Alloy Strip

Electropulsing Aging Treatment of Cu–Ni–Si Sheet for Microforming

Effect of Recovering Damage and Improving Microstructure in the Titanium Alloy Strip under High-Energy Electropulses