Abstract:The CoCrFeNiAl high-entropy alloy, with varying Al compositions, was utilized as the bonding phase in this study to fabricate WC-10%CoCrFeNiAl x (where x represents the mole ratio of Al element, ranging from 0 to 1) hard alloys using the Spark Plasma Sintering method. The investigation focused on elucidating the influence mechanism of microstructure and properties of CoCrFeNiAl x high-entropy alloys on the mechanical properties of WC-10%CoCrFeNiAl x hard alloys. Isothermal oxidation testing was subsequently conducted to examine the impact of Al content on the high-temperature oxidation resistance of WC-10%CoCrFeNiAl x hard alloys. Finally, a comparison was made between the mechanical properties and high temperature oxidation resistance of WC-10%CoCrFeNiAl x hard alloys and conventional WC-6Co cemented carbide. The findings suggest that as the Al content increases, the CoCrFeNiAl x high-entropy alloy undergoes a transition from a single Face-Centered Cubic (FCC) phase to a combination of FCC and Body Centered Cubic (BCC) phases, ultimately transforming into a BCC phase. This evolution results in a gradual enhancement in hardness. The mechanical properties of WC-10CoCrFeNi hard alloy exhibit exceptional characteristics when the Al content is eliminated, with hardness, fracture toughness, and bending strength reaching 1702 MPa, 13.0 MPa·m 1/2 , and 1378 MPa respectively. As the Al content increases in WC-10%CoCrFeNiAl x hard alloys, there is a corresponding increase in hardness while fracture toughness and bending strength gradually decrease. Furthermore, an enhancement in high temperature oxidation resistance is observed. Finally, in comparison to the conventional WC-6Co hard alloy, the mechanical properties of WC-10CoCrFeNiAl x hard alloys exhibit similarity while demonstrating a significant enhancement in oxidation resistance.

Combined Dual-Exposure Test and Dft Investigations into Effects of Interstitial Hydrogen on Oxide Film of Alloy 600 in High Temperature Water

Hydrogen charging effects on the alternation of oxide film formed on Ni, Cr and Alloy 690 in high-temperature water

Effects of in-situ hydrogen charging on the oxide film of iron in high-temperature water: Experiments and DFT calculations

Microstructural understanding of the oxidation and inter-diffusion behavior of Cr-coated Alloy 800H in supercritical water

Study on Precipitation in (cocrfemnni)90al6ti4 High Entropy Alloy

Synergistic Effect of Solid State Hydrogen and Cold Work Pretreatment on Oxide Films Grown on 316L Stainless Steel during Short Term Immersion in Deaerated High Temperature Water at 300 °C

Effect of dissolved oxygen and hydrogen on the stress corrosion cracking behavior of alloy 600 in high temperature water

Effects of the Cr-Depletion on the Stress State of the Sublayer of Ni-Base Alloys Oxidized in High Temperature Water

Investigation of the Oxidation Behavior of Cr20Mn17Fe18Ta23W22 and Microdefects Evolution Induced by Hydrogen Ions before and after Oxidation

The Interdiffusion Behavior of NiCoCrAlYHf Coating Deposited by Arc Ion Plating on Carburized Ni-Based Single Crystal Superalloy

Influence of hydrogen behaviors on tensile properties of equiatomic FeCrNiMnCo high-entropy alloy

Characterization of the oxide film and deuterium permeation behavior of CoCrMnFeNi high entropy alloy oxidized at 550 °C for 24 hours

Near-surface self-resistance hydrogen effect of eutectic high-entropy alloy AlCoCrFeNi2.1

Hydrogen-enhanced oxidation of ferrite phase in stainless steel cladding and the contribution to stress corrosion cracking in deaerated high temperature water

Effects of alternating dissolved oxygen and dissolved hydrogen on the corrosion behavior of alloy 52 in high temperature high pressure water

Impact of Diffusible Hydrogen on Corrosion of Alloy 600 at 288°C: an In-Situ Electrochemical Study

A comparative study on the oxidation behavior and failure mechanisms of conventional NiCoCrAl alloy and in-situ composite AlCoCrFeNi 2.1 eutectic high-entropy alloy at 1300 °C

Hydrogen embrittlement of a precipitation-strengthened high-entropy alloy

Influence of composition and temperature on oxide film formation for Fe-Cr-Ni alloys in simulated PWR primary water

Effect of Al content in CoCrFeNiAl x HEA on mechanical properties and high temperature oxidation resistance of WC-10%CoCrFeNiAl x hard alloy

Hydrogen Diffusion-Induced Crystallographic Changes in Α Plus Β Titanium Alloy