Digital Eddy Current Detection Method Based on High-Speed Sampling with STM32

Xiong Cao,Erlong Li,Zilan Yuan,Kaituo Zheng

DOI: https://doi.org/10.3390/mi15060775

IF: 3.4

2024-06-12

Micromachines

Abstract:The electromagnetic eddy current non-destructive testing system enables the non-destructive analysis of surface defect information on tested materials. Based on the principles of eddy current detection, this paper presents a digital eddy current detection method using high-speed sampling based on STM32. A differential eddy current coil is used as the detection probe, and the combination of a differential bridge and a differential amplifier circuit helps to reduce common-mode noise interference. The detection signal is collected via an STM32-based acquisition circuit and transmitted to the host computer through Ethernet for digital demodulation processing. The host computer performs operations such as smoothing averaging, sinusoidal fitting, and outlier removal to extract the amplitude and phase of the detection signal. The system also visually displays the condition of the tested object's surface in real time through graphical visualization. Testing showed that this system can operate at frequencies up to 8.84 MHz and clearly identify defects as narrow as 1 mm on the surface of the tested steel plate.

chemistry, analytical,nanoscience & nanotechnology,instruments & instrumentation,physics, applied

What problem does this paper attempt to address?

This paper introduces a high-speed sampling digital eddy current detection method based on the STM32 microcontroller for non-destructive testing of material surface defects. Traditional eddy current detection systems suffer from noise interference and complex hardware design issues. The paper proposes the use of differential eddy current coils as detection probes, combined with differential bridge and differential amplification circuits to reduce common-mode noise interference. The STM32 acquisition circuit collects the detection signal and transmits it to the host computer for digital demodulation processing via Ethernet.

The host computer performs smoothing averaging, sine fitting, and outlier removal on the signal to extract the amplitude and phase information of the detection signal. The system also provides a graphical real-time display of the surface state of the tested object. The experiments show that the system can operate at a frequency of up to 8.84 MHz and accurately identify surface defects on steel plates with a width of 1 millimeter.

In summary, the paper addresses the problem of how to improve eddy current detection technology to achieve more efficient, accurate, and cost-effective non-destructive testing of material surface defects, especially by utilizing the STM32 microcontroller and digital processing methods to reduce noise interference and improve detection accuracy.