Abstract:Eddy current testing (ECT) is one of the most important techniques in nondestructive evaluation. A higher probe sensitivity is always pursued in ECT. To improve the probe sensitivity, the near electrical resonance signal enhancement (NERSE) technique was recently proposed. In the NERSE technique, a coaxial cable connecting with the probe coil is introduced to provide a capacitance for the electrical resonance. However, the long coaxial cable is awkward and inconvenient in engineering applications, restraining the usability of such probes. Metamaterials (MTMs) are novel artificial electromagnetic media and have been proved to be effective in manipulating the impedance of a solenoid coil. In other words, in principle, MTMs can be used in the same way as that a coaxial cable in NERSE in ECT. Based on this argument, low-frequency magnetic MTMs are introduced as the probe cores to provide a new approach to achieve the electrical resonance for the NERSE technique. A promising feature of the proposed approach is that the detecting signals and sensitivity are significantly increased due to the extraordinary electromagnetic properties of the MTM. The most salient features of an MTM core over a ferrite core are: 1) effective permeability of the MTM core will vary sharply from a high positive to a high negative values when crossing the resonance frequency, resulting in not only a high magnetic flux density in the tested material but also an extremely large variation of the normalized impedance which is very essential in identifying a crack and 2) electromagnetic properties of an MTM will increase with the increase of frequency, whereas those of a ferrite material usually degrade sharply with the increase of frequency. To demonstrate the advantages of the proposed new probe, comprehensive numerical and experimental studies are conducted, and the results have shown the high performance of the proposed probe. In addition, the proposed MTM-core probe also exhibits a diverse versatility and convenience in engineering applications as compared with the existing NERSE technique.

Advancing eddy current detection probes with magnetoelectric composite Materials: Enhancing crack detection in conductive materials

A Novel Self-Compensating GMR-Based Eddy Current Probe for Hidden Crack Detection

GMR effect based crack ECT for nonferromagnetic metal material

Multiphysics Structured Eddy Current and Thermography Defects Diagnostics System in Moving Mode.

Metamaterial-Core Probes for Nondestructive Eddy Current Testing.

Magnetic Field-Based Eddy-Current Probe Design, Modeling, and Computing Methods for Edge Defect Detection

Eddy Current Probe With Three-Phase Excitation and Integrated Array Tunnel Magnetoresistance Sensors

Low-power eddy current detection with 1-1 type magnetoelectric sensor for pipeline cracks monitoring

Inspection of defects in conductive multi-layered structures by an eddy current scanning technique: Simulation and experiments

A sophisticated design of copper core to converge rotating eddy current control for detecting cracks in conductive materials

Enhanced Nondestructive Testing Using Pulsed Eddy Current and Electromagnetic Ultrasonic Techniques

An Eddy Current Probe for the Detection of Subsuperficial Defects of Any Orientation

Eddy Currents Probe Design for NDT Applications: A Review

Research on key technology of eddy current testing system based on GMR transducer

Differential eddy current testing sensor composed of double gradient winding coils for crack detection

Study of Pulse Eddy Current Probes Detecting Cracks Extending in All Directions

An Eddy Current-Capacitive Crack Detection Probe with High Insensitivity to Lift-Off

Non-destructive testing for carbon-fiber-reinforced plastic (CFRP) using a novel eddy current probe

Differential Koch Planar Eddy Current Probe Sensitivity Boosting by Iron Particulate Sheet

Detection of Surface and Back-Surface Defects on Metal Plate via Rectangular Wave Eddy Current Testing Using Magnetoresistive Sensor

Composite Sensor of EMAT and ECT Using a Shareable Receiver Coil for Detecting Surface and Bottom Defects on the Steel Plate