Abstract:A cryogenic broadband low noise amplifier (LNA) for quantum applications based on a standard 40-nm CMOS technology is reported. The LNA specifications are derived from the readout of semiconductor quantum bits at 4.2 K, whose quantum information signals are characterized as phase-modulated signals. To achieve broadband input matching impedance and low noise figure, the gate-to-drain capacitance of the input transistor is exploited. The goal is to involve a resistive and capacitive load into the input impedance match of a common-source stage with source inductive degeneration. The capacitive load is created by an LC parallel tank whose resonant frequency is lower than the operating frequency. The achieved non-constant in-band equivalent capacitance is proven to be beneficial to input impedance matching. The resistive part of the load is provided by the transconductance of the cascode stage implicitly. An inductor is added to the gate of the cascode transistor to suppress its noise, and a transformer-based resonator with two resonant frequencies serves as the load of the first stage, thus extending the operating bandwidth. Design considerations for the cryogenic temperature operation of the LNA are proposed and analyzed. The LNA achieves a measured gain ( $S_{21}$ ) of 35 ± 0.5 dB, return loss > 12 dB, and NF of 0.75–1.3 dB across the band (4.1–7.9 GHz), with 51.1-mW power consumption at room temperature, while it shows a measured gain of 42 ± 3.3 dB, and NF of 0.23–0.65 dB with 39-mW power consumption at 4.2 K between 4.6 and 8 GHz. To the best of our knowledge, this is the first report of a cryogenic LNA based on a bulk CMOS process working above 4 GHz showing sub-1-dB NF both at room and cryogenic temperatures.

Low-noise large-bandwidth high-gain transimpedance ampli?er for cryogenic STM at 77 K

Ultra-low-noise transimpedance amplifier with a single HEMT in pre-amplifier for measuring shot noise in cryogenic STM

An Inductorless Transimpedance Amplifier Design for 10 Gb/s Optical Communication Using 0.18-Μm CMOS

Design of Differential Variable-Gain Transimpedance Amplifier in 0.18 Μm SiGe BiCMOS

A Wide Dynamic Range Analog Front-End with Reconfigurable Transimpedance Amplifier for Direct ToF LiDAR

Fast low-noise transimpedance amplifier for scanning tunneling microscopy and beyond

A miniature Stirling cryocooler operating above 100 Hz down to liquid nitrogen temperature

A 61.2-dBΩ, 100 Gb/s Ultra-Low Noise Graphene TIA over D-Band Performance for 5G Optical Front-End Receiver

A Cryogenic Sige Low Noise Amplifier Developed for Radio Astronomy

A 29.5 Dbm OOB IIP3 TIA Based on a Two-Stage Pseudo-Differential OTA with R-C Compensation and Cascode Negative Resistance

Cryogenic Capacitive Transimpedance Amplifier for Astronomical Infrared Detectors

Design And Fabrication Of Cryogenic Low Noise Amplifier In Low Rf Band

Characteristics Of Low Noise 800mhz Amplifier At Cryogenic Temperature

A 0.32 $\times$ 0.12 mm$^{2}$ Cryogenic BiCMOS 0.1–8.8 GHz Low Noise Amplifier Achieving 4 K Noise Temperature for SNWD Readout

Cryogenic low noise amplifier with output trap circuit for P Band

Low-noise kinetic inductance traveling-wave amplifier using three-wave mixing

Cryogenic receive coil and low noise preamplifier for MRI at 0.01T

A Cryogenic Broadband Sub-1-dB NF CMOS Low Noise Amplifier for Quantum Applications

A 164-dBΩ Transimpedance Amplifier for Monolithic CMOS-MEMS Oscillators in Biosensing Applications

Ultra Wideband 43 GHz Preamplifier with up to 60 dB adjustable Gain for accurate Noise Figure Measurement of Cryogenic LNAs

Area-efficient CMOS transimpedance amplifier for optical receivers