Abstract:The next generation autonomous sensor nodes are being developed towards ultra-low-power with on-node signal processing capability. The former facilitates battery-less and miniaturized sensors relying on harvested energy, while the latter enables intelligent System-on-Chip (SoC) to sense and process multimodal parameters locally on the sensor nodes. As for analog front-end (AFE), a straightforward solution for low power and digital compatibility is to reduce its supply voltage to the sub-volt range. However, supply scaling is less friendly to conventional AFEs, which often require large dynamic range (DR) and high linearity, Furthermore, practical considerations of low noise, high input-impedance <tex xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">$(\mathrm{Z}_{\text{in}})$</tex> and sensor-dependent bandwidth (BW) further exacerbate the challenges to comply with versatile sensors. To realize the low-voltage AFE, time-domain (TD) direct digitization architectures [1]–[5] were proposed (Fig. 1). The <tex xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">$\mathrm{G}_{\mathrm{m}}-\mathrm{C}$</tex> based delta-sigma modulator <tex xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">$(\Delta\Sigma \mathrm{M})$</tex> with a built-in TD loop filter benefits from high input impedance and higher order noise shaping [1], but the <tex xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">$\mathrm{G}_{\mathrm{m}}$</tex> exhibits nonlinearity for a large input signal. Alternatively, the VCO-based AFEs provide better supply voltage scalability and inherent <tex xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">${1}^{\text{st}}$</tex> -order noise shaping. The open-loop VCO-based AFE [2] benefits from a small chip area, but suffering from the tradeoff between linearity and input range. While the closed-loop VCO-based AFE solves this issue [3]–[5], this topology often needs a highly linear feedback DAC that notably reduces the input impedance of the AFE, unless impedance boosting buffers are used [6]. Besides, the closed-loop VCO based AFEs needs to be clocked continuously, resulting in power overhead.

A Wide Dynamic Range Analog Front-End with Reconfigurable Transimpedance Amplifier for Direct ToF LiDAR

An On-Chip AC Coupled AFE with Asymmetric Output Stage for D-Tof LiDAR

A Wideband and High Output Swing Analog Frontend Circuit for FMCW LiDAR

High Sensitivity and Wide Dynamic Range Analog Front-End Circuits for Pulsed TOF 4-D Imaging LADAR Receiver

A Low-Power Multimode Eight-Channel AFE for Dtof LiDAR

A 16-Channel Analog CMOS SiPM with On-Chip Front-End for D-ToF LiDAR

A CMOS AFE Array With DC Input Current Cancellation for FMCW LiDAR

Optimization of System Design and Calibration Algorithm for SPAD-Based LiDAR Imager

A CMOS Optoelectronic Transimpedance Amplifier Using Concurrent Automatic Gain Control for LiDAR Sensors

A 49.5 Μw Multichannel Time-to-Digital Converter with 2D/3D Imaging Fusion for APD LiDAR Sensors

A Linear-Mode LiDAR Sensor Using a Multi-Channel CMOS Transimpedance Amplifier Array

DTOF Image LiDAR With Stray Light Suppression and Equivalent Sampling Technology

A 110-Dbω, 113-Mhz Variable-Gain Transimpedance Amplifier for Flash 3D Imaging Systems

A wide dynamic range laser rangefinder with cm-level resolution based on AGC amplifier structure

A Linear Dynamic Range Receiver with Timing Discrimination for Pulsed TOF Imaging LADAR Application

A dToF Ranging Sensor with Accurate Photon Detector Measurements for LiDAR Applications

A Low-Power i-ToF LiDAR With Nonlinearity Self-Calibration Technique

A Low-Power Optoelectronic Receiver IC for Short-Range LiDAR Sensors in 180 nm CMOS

Focal Plane Array Chip with Integrated Transmit Antenna and Receive Array for LiDAR

Low-Noise Low-Power Ultrasound AFE with Continuous TGC Built in Both TIA and Beamformer.

A 0.8V/0.6V 2.2μW Time-Domain Analog Front-End with <tex>$540\text{mV}_{\text{pp}}$</tex> Input Range, 81.6dB SNDR and <tex>$80\mathrm{M}\Omega$</tex> Input Impedance