Mode I Fracture Propagation and Post-Peak Behavior of Sandstone: Insight from AE and DIC Observation

Xiaoran Wang,Shuxin Liu,Xiaofei Liu,Tiancheng Shan,Xin Zhou,Hui Xie,Jinhua Wang

DOI: https://doi.org/10.1016/j.engfracmech.2024.110093

IF: 5.4

2024-01-01

Engineering Fracture Mechanics

Abstract:Microcracks generated at the crack tip, particularly in quasi -brittle materials such as sandstone, give rise to a non-linear region known as the fracture process zone (FPZ), which cannot be analyzed using linear elastic fracture mechanics (LEFM). To gain insights into the nonlinear fracturing behavior of rock, this study conducted three-point bending experiments on sandstone beams with prefabricated notch. Stable mode -I fracture propagation during the post -peak stage was achieved by the monotonic increment of crack mouth opening displacement (CMOD) measured by a clip gauge. The acoustic emission (AE) and digital image correlation (DIC) techniques were utilized to visually track the detailed crack propagation process from both micro and macro perspectives. Nonlinear fracture parameters, including FPZ length, were identified by AE and DIC measurements and compared with the theoretical calculation. A nonlinear fracture criterion relating applied load, equivalent crack length, and stress intensity factor were established, from which the theoretical CMOD-P curve at the post -peak stage were obtained and validated with experimental measurement from MTS machine. The results reveal that microcracks formulating the FPZ materialize in the pre -peak stage, with the majority emerging post -peak to facilitate the propagation of the traction -free crack and FPZ in the loading direction, as evidenced by AE locations and DIC displacement gradient. Throughout the crack propagation process, over 65 % of microcracks are estimated to be tensile mode based on both AF/RA and polarity analysis, aligning with anticipated outcomes from macroscopic three-point bending fracture tests. Energy dissipation primarily occurs within the FPZ to facilitate separation of crack faces, with the dissipated energy region advancing towards the beam boundary. By integrating AE source locations and DIC displacement gradient, the FPZ length of the 3 -point -bending sandstone specimens is determined to be l p = 8.1 mm, slightly exceeding the theoretical FPZ lengths calculated by the Irwin model ( l p = 7.0 mm) and the Dugdale-Barenblatt model ( l p = 7.6 mm). Using a non-linear fracture criterion that incorporates the FPZ and employing the in -time equivalent crack length measured by AE and DIC as an intermediate variable, the theoretical applied load -crack length curve during the post -peak stage is calculated, showing close agreement with load cell measurements with a negligible error of approximately 2 %. Furthermore, the theoretical post -peak CMOD vs. load curve aligns with experimentally obtained results, demonstrating a non-linear crack propagation speed at a constant CMOD rate, wherein crack propagation speed decreases as crack length increases.