Abstract:Arm-locking technique has been a focus of attention as one of the means to suppress the laser phase noise in space-based gravitational wave (GW) detector. The main idea of the arm-locking technique is to transfer the stability of the detector arm length to laser frequency by introducing a feedback control loop. Generally, laser phase noise will be suppressed by an amount similar to the magnitude of the controller gain. However, on the one hand, clock-jitter noise and optical bench motion noise, as the noise floor of the arm-locking technique, need to be suppressed. On the other hand, limited by the Doppler frequency pulling, the gain of the controller generally cannot be too large. It means that even if we do not consider clock-jitter noise and optical bench motion noise, it is difficult to suppress laser phase noise below the noise floor only by arm-locking technique. In this work, we combine self-referenced optical frequency combs (OFC) and arm-locking technique to generate clock signals that are coherently referenced to the closed-loop laser beams, so that the clock-jitter noise is also suppressed by about the level of controller gain. We conduct a simulation on the above configuration, and the results show that the performance of the arm-locking is limited by clock-jitter noise in the low-frequency band. To address the issue of insufficient laser phase noise suppression by the arm-locking technique, we further investigate Time-delay interferometry (TDI) combinations under outputs of arbitrary arm-locking configurations. We obtain the equations for eliminating laser phase noise. To ensure that the TDI combinations can directly operate in the time domain, we derive a restricted solution space by assuming a specific form for the solutions.

Increase in the Signal-to-noise Ratio of the Beat Note Between a Frequency Comb and a Continuous-Wave Laser

Enhancing the signal-to-noise ratio of optical frequency beating using open-loop photonic crystal fiber

A Signal to Noise Ratio Measurement for Single Shot Laser Pulses by Use of an Optical Kerr Gate

Laser frequency stabilization for continuous-wave laser enhanced direct frequency comb spectroscopy system

Frequency comb interference spectroscopy using a fiber laser comb and a multi-colour laser

Improving the accuracy of a dual-comb interferometer by suppressing the relative linewidth

Laser heterodyne interferometric signal processing method based on rising edge locking with high frequency clock signal.

Optimizing the architecture for coherent beat note acquisition in LISA

Research on the enhancement of signal‐to‐noise ratio by radio frequency white noise in compact dense‐pattern multipass cell for trace gas detection

Design of Pulse Laser Signal Detection System Based on Full Waveform Sampling

Suppression of Clock-Jitter Noise and Laser Phase Noise in Arm Locking

Beat note stabilization of a 10-60 GHz dual-polarization microlaser through optical down conversion

Impact of Laser Intensity Noise on Dual-Comb Absolute Ranging Precision

Efficient Laser Noise Reduction Method Via Actively Stabilized Optical Delay Line.

Generation and Noise Analysis of a Wide-Band Optical -Frequency Comb Based on Recirculating Frequency Shifter

A Coherent Detection Method With 10<sup>6</sup> Higher Intensity Response Sensitivity Than Normal Heterodyne Interferometry

An Integrated Wavemeter Based on Fully-Stabilized Resonant Electro-Optic Frequency Comb

Simple Hybrid Wire-Wireless Fiber Laser Sensor by Direct Photonic Generation of Beat Signal.

Ultrafast Resolution-Enhanced Digital Optical Frequency Comb-Based BOTDA with Pump Pulse Array Coding

Window Filtering Algorithm for Pulsed Light Coherent Combining of Low Repetition Frequency

Frequency Response Bandwidth Calibration of High Speed Photodetector Using Frequency-Stabilized Laser by Optical Heterodyne Technique