Abstract:The iodine-stabilized 532 nm Nd:YAG laser plays an important role in the realization of the unit of length "meter (m)", absolute gravimeter, gravitational waves detaction, precision spectroscopy, distance metrology, and so on. Absolute frequency measurement and calibration of the laser are of great significance for the performance evaluation of the laser. The previous method of extending the erbium-doped fiber optical frequency comb (Er-FOFC) to the wavelength of 532nm was to first amplify the seed light, then frequency-doubled with a periodic polarization lithium niobate crystal, and finally couple it into a photonic crystal fiber to expand the spectrum to the 532nm band. With such technique, the a signal-to-noise ratio (SNR) of the beat signal between the iodine-stabilized 532 nm Nd:YAG laser and the Er-FOFC is approximately 30 dB. Moreover, the SNR of the beat signal was unstable, resulting in the errors in frequency measurement with a counter. This is not conducive to the long-term frequency measurement of the iodine-stabilized 532 nm Nd:YAG laser. Therefore, a method that can obtain both high SNR and long-term stable beat signals is required. In this paper, an Er-FOFC was developed. The spectral enhancement of its broadened at 1 μm was carried out, and then expanded to the wavelength at 532 nm with a frequency-doubling crystal. The output power of the Er-FOFC was 20 mW, which was first amplified to 370 mW by an Er-fiber amplifier and then compressed to a pulse width of 45.7 fs. Subsequently, the spectrum was extended to cover the wavelength at 1 μm with a highly nonlinear fiber, resulting in an output power of 180 mW. The broadened spectrum at 1 μm was amplified to 601 mW by a Yb-fiber amplifier, and the compressed power increasing to 420 mW. Using an MgO: PPLN crystal, the compressed laser was frequency-doubled to produce a 532 nm laser output with 155 mW power and a doubling efficiency of 36%. Utilizing this system, the absolute frequency measurements were conducted on the fundamental frequency light at 1064 nm and the doubled frequency light at 532 nm from the iodine-stabilized 532 nm Nd:YAG laser, yielding a beat signal with a SNR of greater than 40 dB. This SNR represents a 13 dB improvement compared with the results obtained when an amplified seed light is frequency-doubled using PPLN and then coupled into a PCF for direct spectral broadening to cover the 532 nm band. Over several days of continuous monitoring, there was no observed risk of SNR degradation. Moreover, subsequent frequency measurements were carried out continuously for over several hours, with the results maintaining consistency with recommended values.

Enhancing the signal-to-noise ratio of optical frequency beating using open-loop photonic crystal fiber

Increase in the Signal-to-noise Ratio of the Beat Note Between a Frequency Comb and a Continuous-Wave Laser

Generation of a 25-Line Flattened Optical Frequency Comb and Its Coherent Beating Properties.

Optical Frequency Comb Generation from a 1.65 Μm Single-Section Quantum Well Laser.

Long-term Frequency-Stabilized Er:fiber-based Optical Frequency Comb with Nonlinear Amplifying Loop Mirror

Improvement of the Fceo S/N of Er-doped Fiber Laser Combs with Super-Continuum Power Distribution Optimization

Realization of frequency calibration for 532 nm wavelength laser based on spectral enhancement technology

Enhancing the Stabilizing Robustness for Optical Frequency Comb

Robust optical-frequency-comb based on the hybrid mode-locked Er:fiber femtosecond laser

Attosecond-Resolution Er:Fiber-Based Optical Frequency Comb

Tapered Photonic Crystal Fiber for Simplified Yb:fiber Laser Frequency Comb with Low Pulse Energy and Robust F_ceo Singals

Recirculating Frequency Shifting Based Wideband Optical Frequency Comb Generation by Phase Coherence Control

Method for the generation of microwave frequency combs based on a Vernier optoelectronic feedback loop

Tunable optical frequency comb from a compact and robust Er:fiber laser

Beat Frequency Nonlinearity Compensation Based on Fiber Reference Channel in Laser Frequency Scanning Interferometer

Sub-femtometer-resolution absolute spectroscopy with sweeping electro-optic combs

Optomechanical Frequency Comb Based on Multiple Nonlinear Dynamics

Simultaneously Reducing the Intensity and Frequency Noise of Single-Frequency Phosphate Fiber Laser

All Polarization-Maintaining Er:fiber-based Optical Frequency Comb for Frequency Comparison of Optical Clocks

Improving the accuracy of a dual-comb interferometer by suppressing the relative linewidth

Optical frequency comb generation based on spectral broadening of a phase locked dual-wavelength microcavity laser