Abstract:We control the spectrum of supercontinuum generation by phase shaping the driving pulse, greatly increasing power at wavelengths of interest. Previous work generally optimized one or two wavelength ranges, with spectral broadening below an octave, using spatial light modulators. We optimize a strongly nonlinear octave-spanning supercontinuum for six wavelengths, and we use much a more practical fully fiberized system, using temperature-controlled chirped fiber Bragg gratings. Our particular application is optical frequency transfer with an Er fiber frequency comb. We aim to replace multiple supercontinuum branches for f-2f interferometry and clock wavelengths with a single shaped branch that provides all the needed wavelengths, removing multiple path phase noise. We generated an optimized spectrum with strong outputs at the half harmonics of Yb, Ca, and Sr transitions: 1157, 1315, and 1397 nm, 1050 and 2100 nm for f-2f interferometry, and 1556 nm for c-band referencing. Without optimization, some target lines might be tens of nW, but we increase them to about 100 nW or more. Optimizing only one or two clock lines can further increase output by hundreds of nW. We confirmed the coherence of the shaped spectrum by interference with a second, unshaped supercontinuum branch with a 70 MHz acousto-optical frequency shift. The interference had strong contrast, and the beat notes had over 40 dB signal to noise at 100 kHz resolution bandwidth, showing suitability for high precision frequency comparison and locking.

Improvement of the Fceo S/N of Er-doped Fiber Laser Combs with Super-Continuum Power Distribution Optimization

Compensation of Dispersion-Induced Power Fading with Adjustment-Free Operation

Nonlinearity Optimization of Dissipative-Soliton Fiber Laser for Generation of Pulses with 350 Kw Peak Power

Tapered Photonic Crystal Fiber for Simplified Yb:fiber Laser Frequency Comb with Low Pulse Energy and Robust F_ceo Singals

All-Fiber Wideband Supercontinuum Generation in Short Hybrid Highly Nonlinear Fibers With a Femtosecond Erbium-Doped Fiber Laser

Green‐light‐enhanced Super‐continuum Generation in Tapered Photonic Crystal Fibre for Efficient F Ceo Detection of Yb:fibre Laser Frequency Combs

Wavelength-Spacing Tunable Multi-Wavelength Erbium-Doped Fiber Laser Incorporating A Semiconductor Optical Amplifier

A 1 Μm Laser Output Based on an Er-doped Fiber Femtosecond Laser

Optical Frequency Comb Generation from a 1.65 Μm Single-Section Quantum Well Laser.

Optimization of supercontinuum generation in highly nonlinear fiber for DFG based mid-infrared frequency comb

Stabilizing Carrier-Envelope Offset Frequency of a Femtosecond Laser Using Heterodyne Interferometry.

Generation of Octave-Spanning Super-Continuum in Tapered Single Mode Fibre Pumped by Femtosecond Yb:YCOB Laser

1 GHz Spaced Er:fiber Frequency Combs Based on NPE Mode-Locked Laser

Performance Improvement of a Supercontinuum Continuous-Wave Optical Source

High-efficiency and high-power single-frequency fiber laser at 1.6 um based on cascaded energy-transfer pumping

Supercontinuum Optimization at Six Spectral Lines for Frequency Metrology Using Phase Shaping

End-pump silica-fluoride fiber combiner utilizing tapering and assembling technique for mid-infrared laser systems

Enhancing the signal-to-noise ratio of optical frequency beating using open-loop photonic crystal fiber

Signal-to-noise ratio improvement of a supercontinuum continuous-wave optical source using a dispersion-imbalanced nonlinear optical loop mirror

Tunable optical frequency comb from a compact and robust Er:fiber laser

Robust optical-frequency-comb based on the hybrid mode-locked Er:fiber femtosecond laser