Abstract:Selectivity is the key parameter in industrial ethylene oxide (EO) production by oxidation of ethylene with oxygen on Ag/α–Al2O3 catalysts. Accurate temperature control in wall-cooled multitubular fixed-bed reactors and chlorination of the silver surface by feeding small chlorinated hydrocarbons such as 1,2-dichloroethane (DCE) are required to fine-tune electrophilicity and surface oxygen coverage for maximum EO selectivity at economic ethylene conversion. Temperature and molar flow rate profiles of C2H4, O2, EO, CO2, H2O, DCE, and chlorine-containing reaction products vinyl chloride (VC) and ethyl chloride (EC) were measured in a compact profile reactor (CPR) and in a pilot-scale profile reactor (PSPR) to explore the spatial interplay between DCE concentration, temperature, inlet flow rate, and O2 conversion. Chlorine and oxygen compete for the same active silver sites despite more than 4 orders of magnitude different concentrations (ppm vs vol %). Chlorine coverage increases from inlet to outlet due to the decreasing partial pressure of O2 along the bed, leading to shutdown of all reactions if all active Ag sites are blocked by chlorine. A kinetic model is derived from a dual-site mechanism taken from the literature. Kinetic parameters are determined from differential initial rate measurements, Arrhenius plots, and by fitting the rate expressions implemented in a plug flow model to the species and temperature profiles in the CPR. A very good agreement is reached. PSPR profiles are modeled by implementing the derived kinetic model into a 2D pseudohomogeneous reactor model. At conversions <10%, the experimental profiles are well captured, but the model fails to accurately reproduce the point of thermal runaway in the catalyst bed of the PSPR caused by a too low reactor temperature and resulting insufficient chlorine coverage of the silver surface.

Square-pyramidal Subsurface Oxygen [ag4oag] Drives Selective Ethene Epoxidation on Silver

Reaction gas induced activity enhancement for silver catalyst in ethylene epoxidation

Active Site of Catalytic Ethene Epoxidation: Machine-Learning Global Pathway Sampling Rules out the Metal Sites

Cs-promoted Active Species for Ag-catalyzed Ethylene Epoxidation

Increased Silver Activity For Direct Propylene Epoxidation Via Subnanometer Size Effects

What leads to direct epoxidation? An exhaustive DFT investigation of electrophilic oxygen mediated epoxidation of ethylene on Ag(100)

The Performance of Ethylene Partial Oxidation on Group IB Metal Stepped Surfaces

Understanding Trends in Ethylene Epoxidation on Group IB Metals

Tailoring the Electronic Metal‐Support Interactions in Supported Silver Catalysts through Al modification for Efficient Ethylene Epoxidation

Overview of Selective Oxidation of Ethylene to Ethylene Oxide by Ag Catalysts

Revealing the Nature of Active Oxygen Species and Reaction Mechanism of Ethylene Epoxidation by Supported Ag/α-Al 2 O 3 Catalysts

First-principles investigation of Ag-Cu alloy surfaces in an oxidizing environment

High-Loading Single-Atomic-Site Silver Catalysts with an Ag 1 –C 2 N 1 Structure Showing Superior Performance for Epoxidation of Styrene

High-Loading Single-Atomic-Site Silver Catalysts with an Ag<sub>1</sub>-C<sub>2</sub>N<sub>1</sub> Structure Showing Superior Performance for Epoxidation of Styrene

Revealing Activity of Symmetrical and Asymmetrical Ag2O‐MOx (M = Cu, Fe, Zn) Catalysts via DFT Calculations for Direct Propylene Epoxidation

Heterogeneous Iridium Single-Atom Molecular-like Catalysis for Epoxidation of Ethylene.

Selective Oxidation of Ethylene to Ethylene Oxide on Silver Catalysts at Industrial Conditions: Reactor Profiles, Kinetics, and Chlorine Inhibition

Insights into the function of silver as an oxidation catalyst by ab initio, atomistic thermodynamics

In‐situ Raman Studies of Ethylene Oxidation at Ag(111) and Ag(110) under Catalytic Reaction Conditions

Ag-Cu alloy surfaces in an oxidizing environment: a first-principles study