Abstract:In this paper, we employ the anisotropic bulk approximation to successfully implement the electromagnetic modeling of superconducting coils wound with rare-earth-barium-copper-oxide (REBCO) tapes based on the H-formulation, in which the field-dependent critical current density and highly nonlinear E-J characteristic are considered. The total number of turns in the stacks of REBCO pancake coils is up to several thousand. We validate the anisotropic bulk model by comparing the ac loss of a small four-pancake coil between the bulk model and the original model which takes the actual thickness of the superconducting layer into account. Then, the anisotropic bulk model is used to investigate the self-field problem of the REBCO prototype coils of the National High Magnetic Field Laboratory 32 T all-superconducting magnet. The field and current density distributions are obtained, and an obvious shielding effect is observed at the top and bottom of the coils. The ac losses in the first and second cycles are calculated. The former is crucial to the design of the cooling system and the latter relates to the routine consumption of the liquid helium. It is found that the ac loss in the first cycle is 2.6 times as large as that in the second cycle. We also study the ac loss dependences on some key parameters (the critical current, n-value and ramp rate of the applied current). It is found that both in the first and second cycles, the ac loss increases with decreasing critical current. Moreover, the influence of the n-value on the ac loss is negligible. In addition, the ac loss decreases logarithmically with increasing ramp rate. However, the average power loss increases linearly with increasing ramp rate. We also compare some analytical estimates with the simulation result for the ac loss of the dual prototype coils. It is found that the results of Bean's slab model are closer to the simulation result. The presented model is a useful tool to help us understand electromagnetic behavior and ac losses in REBCO high field coils. It also provides a basis to analyze the mechanical characteristics in the coils in the future.

Research on the Evolution Characteristics of REBCO Inductance for 19 T All-Superconducting Magnet

Design and Preliminary Tests of a 20-T REBCO Insert Coil for a 35-T All Superconducting Magnet

Progress in the Construction of a 20 T REBCO Insert Coil for High-Field All-Superconducting Magnets

Design, Fabrication, and Test of a 12 T REBCO Insert for a 27 T All-Superconducting Magnet

Electromagnetic Design and Mechanical Behavior Analysis of an 850 MHz All REBCO Nuclear Magnetic Resonance Magnet

Study on the Arrangement of REBCO Double-Pancake Coils with Different Critical Currents in 30-T Superconducting Magnets

Design of a 20 T Class REBCO Insert in a 15 T Low Temperature Superconducting Magnet

A 15-T Rebco Insert for A 30-T All Superconducting Magnet

Generation of 25 T with an all-superconducting magnet system: field profile and field quality measurements of a layer-wound 4 T REBCO insert coil for a 21 T LTS magnet

Numerical Analysis of the Electromechanical Behavior of High-Field REBCO Coils in All-Superconducting Magnets

26.86-tesla direct-current magnetic field generated with an all-REBCO superconducting magnet

Experimental and Simulation Studies of SCIF Considering Non-Uniform Critical Current

Design of a 3 T REBCO Dipole Magnet Considering Screening Current Induced Magnetic Field and Its First Test Result at 77 K

The Performance of First CORC Cable Solenoid Insert for Development of CFETR High-Field Magnet

Electromagnetic Modeling of REBCO High Field Coils by Theh-Formulation

Numerical Analysis of Screening-Current Induced Strain in a 16 T REBCO Insert Within a 20 T Background Field

Test of an 8.66-T REBCO Insert Coil with Overbanding Radial Build for a 1.3-Ghz LTS/HTS NMR Magnet

Experiment and Numerical Modeling of Current Distributions Inside REBCO Tapes of No-Insulation Superconducting Magnet Coils Under Time-Varying Fields

Performance of First Insert Coil with REBCO CICC Sub-Size Cable Exceeding 6 Ka at 21 T Magnetic Field

Performance Test of REBCO CICC Sub-Cables with 10 Ka Current under 20 T Background Field

Numerical Simulation of Magnetic Field for Compact Electromagnet Consisting of REBCO Coils and Iron Yoke