Abstract:Shield method have been commonly used in water conveyance tunnels. To improve the bearing capacity of a shield tunnel under internal water pressure, a reinforced concrete lining is constructed inside the segmental linings to form a composite lining structure. However, cracks typically occur in reinforced concrete inner linings. In this study, a prototype test was performed to investigate the failure process of a composite lining. Based on the test observations, the progressive failure process of the composite lining experienced four stages. In the elastic stage, the stress and deformation of the composite lining increased linearly with the internal pressure, and no cracks appeared. In the cracking stage, cracks first occurred in the inner lining near the joints and were subsequently uniformly distributed along the circumferential direction. In the joint damage stage, the cracking of the inner lining caused more internal pressure to transmit to the segmental lining. As the internal pressure increased, compressive damage occurred in the handholes of the segmental joints. Finally, in the failure stage, the damage to the joints deteriorated and more internal pressure was borne by the rebar of the inner lining. Shear failure typically occurred at the welding point of the inner-lining rebar, followed by joint fracture near the welding point. Finally, the composite lining lost its ability. The test results showed that cracking of reinforced concrete inner lining remarkably decreased the tensile stiffness of composite lining. Consequently, the joint opening and convergence of the tunnel developed at a higher rate, posing a threat to the operational safety of the tunnel. The tensile stiffness is a key factor related to the deformation and bearing capacity of a shield tunnel. Therefore, an analytical solution was established to calculate the tensile stiffness of the composite lining after cracking. The analytical solution matched the test results well. In addition, the effects of the thickness and reinforcement ratio of the inner lining were analysed. The results suggested that increasing the reinforcement was more beneficial in improving the tensile stiffness of the composite lining.

Interface Failure of Segmental Tunnel Lining Strengthened with Steel Plates Based on Fracture Mechanics

Analytical Method for Segmental Tunnel Linings Reinforced by Secondary Lining Considering Interfacial Slippage and Detachment

Analytical Model for Segmental Tunnel Lining with Nonlinear Joints

Analytical Solution for Segmental-Tunnel Lining Incorporating Interaction Between Adjacent Rings

Full-scale Loading Test for Shield Tunnel Segments: Load-bearing Performance and Failure Patterns of Lining Structures

Numerical analysis of tunnel segments strengthened by steel–concrete composites

Experimental Study on Direct Shear Performance of Concrete-Concrete Interface of Prefabricated Structure Sleeve Grouting Connection

Mechanism of Load Introduction and Transfer Within Steel-Encased CFST Members with Shear Connections

Detailed damage mechanism of deformed shield tunnel linings reinforced by steel plates

Experiments and Numerical Simulation of the Reinforcement Effect of Channel-Steel-reinforced Shield Tunnel Segments under Unloading Conditions

Structural Behavior of Triple-Layer Composite Lining of a Water Conveyance Tunnel: Insight from Full-Scale Loading Tests

Full scale tests and a progressive failure model to simulate full mechanical behavior of concrete tunnel segmental lining joints

An elastic-plastic cohesive zone model for metal-ceramic interfaces at finite deformations

Full-scale experimental investigation on progressive failure characteristics of shield segmental lining connected through segmental joints containing ductile-iron joint panels

Failure mechanism and strengthening effect of shield tunnel lining reinforced by steel plates with corbels

Failure process and tensile stiffness of shield tunnel with reinforced concrete inner lining under internal water pressure

Full-scale experimental investigation into stability of segment-SCC-steel tube lining under external pressure

Numerical Assessment of the Structural Damage of a Composite Lining Water Conveyance Tunnel Subjected to Reverse Fault Conditions

Experimental study on the mechanical behavior of segmental joints of shield tunnels strengthened by a steel plate-UHPC composite

Numerical analysis of size effect on the deformation behavior and damage evolution mechanism of segmental tunnel lining rings

An analytical model of longitudinal joints in the segmental lining of shield tunnels with considering geometric nonlinearity