Abstract:Ultrahigh-performance concrete (UHPC) is a novel material demonstrating superior mechanical, durability and sustainability performance. However, its implementation in massive structures is hampered by its high initial cost and the lack of stakeholders' confidence, especially in developing countries. Therefore, the present study explores, for the first time, a novel application of UHPC, incorporating hybrid steel fibers in precast tunnel lining segments. Reduced scale curved tunnel lining segments were cast using UHPC incorporating hybrid 8 mm and 16 mm steel fibers at dosages of 1%, 2% and 3% by mixture volume. Flexural and thrust load tests were conducted to investigate the mechanical behavior of UHPC tunnel lining segments thus produced. It was observed that the flow of UHPC mixtures decreased due to steel fibers addition, yet steel fibers increased the mechanical and durability properties. Flexural tests on lining segments showed that both the strain hardening (multiple cracking) and strain softening (post-peak behavior) phases were enhanced due to hybrid addition of steel fibers in comparison with the control segments without fibers. Specimens incorporating 3% of hybrid steel fibers achieved 57% increase in ultimate load carrying capacity and exhibited multiple cracking patterns compared to that of identical UHPC segments with 1% fibers. Moreover, segments without fibers incurred excessive cracking and spalling of concrete at the base under the thrust load test. However, more stable behavior was observed for segments incorporating steel fibers under the thrust load, indicating its capability to resist typical thrust loads during tunnel lining field installation. This study highlights the potential use of UHPC with hybrid steel fibers for improved structural behavior. Moreover, the use of UHPC allows producing structural members with reduced cross-sectional dimensions, leading to reduced overall structural weight and increased clear space.

Experimental study on the mechanical behavior of segmental joints of shield tunnels strengthened by a steel plate-UHPC composite

Interface Failure of Segmental Tunnel Lining Strengthened with Steel Plates Based on Fracture Mechanics

Reinforcement Effect of U-Steel Reinforced Shield Segment Under Excavation Unloading of Side Foundation Pit

Full-scale Experimental and Structural Characterization Study of Shield Tunnel Reinforcement under Ground Stacking Loads

Numerical Analysis of New Stainless-Steel Corrugated-Plate Reinforcement of Shield-Tunnel Segmental Joints Based on Virtual-Tracking-Element Technology

EXPERIMENTAL RESEARCH ON TENSILE AND SHEAR BEHAVIOUR OF THE INTERFACE BETWEEN NON-STEAM-CURED UHPC AND STEEL PLATE STRUCTURE

Shear behavior of pre-damaged RC beams strengthened with steel plate and UHPC

Experimental study on demountable steel ultra-high performance concrete composite slabs under hogging moment

Experimental studies of headed stud shear connectors in UHPC Steel composite slabs

Flexural Performance of UHPC–Concrete–ECC Composite Member Reinforced with Perforated Steel Plates

Effect of a Novel Joint Connection of UHPC Wet Joint and Tapered Sleeve Locking-Type Couplers on the Lateral Cyclic Response of Precast Segmental Railway Bridge Columns

Numerical analysis of tunnel segments strengthened by steel–concrete composites

Experimental and numerical investigations on direct shear performance of UHPC dry joints

Experimental study on flexural behavior of partially precast high-strength steel reinforced ultra-high performance concrete beam

Experiment and finite element analysis of bending behavior of high strength steel-UHPC composite beams

Experimental Study on Interfacial Shear Behavior of PBL Shear Connector Deeply Embedded in UHPC

Experimental Study on Seismic Behavior of a Novel RC Slab- SC Wall Joint Based on UHPC and Rebar - Steel Plate Lap Splices

Experimental and Numerical Study on Flexural Behaviors of Steel-UHPC Composite Beams under Hogging Moment

Mechanical Behavior of Ultrahigh-Performance Concrete Tunnel Lining Segments

Interfacial shear and flexural performances of steel-precast UHPC composite beams: Full-depth slabs with studs vs. demountable slabs with bolts

Experimental and Numerical Investigation of the Interfacial Properties of Non-Steam-cured UHPC-steel Composite Beams