Abstract:The optimization of thermal management (i.e. improving heat generation and dissipation) in a proton exchange membrane fuel cell (PEMFC) is a vital method to enhance its energy conversion efficiency. However, few studies have focused on the temperature uniformity in a massive PEMFC stack with a coolant flow channel. The aim of this study is to investigate the temperature characteristics and power performance affected by the inlet coolant condition in a massive PEMFC stack and establish a correlation of the temperature uniformity with the affected inlet coolant temperature for thermal management and power performance improvements in PEMFCs. The power density of a massive PEMFC stack with an active area of 326 cm 2 (302 mm × 108 mm) of the designed stack cells with a coolant flow channel were experimentally evaluated, and the thermal characteristics were also analyzed using monitored temperatures inside specific stack cells by considering the different inlet coolant temperatures of 50 °C, 60 °C and 70 °C. It was found that the stack had the greatest power performance and minimum temperature increment of the inlet coolant at a temperature of 70 °C. The water phase transition heat transfer inside the stack was found to play a significant role in the thermal balance. The temperature distribution of the stack cell had a symmetrical convex curve from the center to the margin. The temperature gradient of the stack cell along the coolant flow direction was introduced to characterize the temperature uniformity. The linear development between the temperature gradient and the current density was determined adequately using a curve fitting. In addition, a lower fitting linear slope was obtained for a higher inlet coolant temperature, and this signified that a higher inlet coolant temperature could improve the temperature uniformity and power performance of PEMFCs.

Experimental Investigation on the Open Cathode Air-Cooled Proton Exchange Membrane Fuel Cells: Optimum Operating Parameters and Control Strategies

Experimental study on the dynamic response of voltage and temperature of an open-cathode air-cooled proton exchange membrane fuel cell

Temperature Optimization and Control of Optimal Performance for a 300W Open Cathode Proton Exchange Membrane Fuel Cell

The Performance Improvement of Membrane and Electrode Assembly in Open-Cathode Proton Exchange Membrane Fuel Cell

Experimental study on the thermal management of an open-cathode air-cooled proton exchange membrane fuel cell stack with ultra-thin metal bipolar plates

Air flow and pressure optimization for air supply in proton exchange membrane fuel cell system

Improvement of Temperature and Humidity Control of Proton Exchange Membrane Fuel Cells

Optimization of control strategy for air-cooled PEMFC based on in-situ observation of internal reaction state

Influence of cathode air supply mode on the performance of an open cathode air-cooled proton exchange membrane fuel cell stack

Comprehensive performance assessment and multi-objective optimization of high-power proton exchange membrane fuel cell system under variable load

Experimental Study on Anode and Cathode Pressure Difference Control and Effects in a Proton Exchange Membrane Fuel Cell System

Effects of operating conditions on the performance uniformity of the proton-exchange membrane fuel cell stack

Control-Oriented Modeling of Purging Process and Cold Start of Proton-Exchange Membrane Fuel Cell

Optimization of gas feeding operations for polymer electrolyte membrane fuel cell with the co-flow feeding gas mode

Optimal operating conditions to maximize the net power of polymer electrolyte membrane fuel cells: The stack-system interface of a commercial 18 kW module

Recent advances in heat and water management of forced-convection open-cathode proton exchange membrane fuel cells

Investigation of non-uniform temperature distribution in air-cooled proton exchange membrane fuel cells with multizone temperature measurement

Experimental study of the thermal and power performances of a proton exchange membrane fuel cell stack affected by the coolant temperature

Experimental study of voltage uniformity and stability of H 2 /O 2 PEM fuel cell stack with dead-end anode and recirculation cathode

An experimental study for optimizing the energy efficiency of a proton exchange membrane fuel cell with an open-cathode

Numerical simulation on purge strategy of proton exchange membrane fuel cell with dead-ended anode