Abstract:The optimization of thermal management (i.e. improving heat generation and dissipation) in a proton exchange membrane fuel cell (PEMFC) is a vital method to enhance its energy conversion efficiency. However, few studies have focused on the temperature uniformity in a massive PEMFC stack with a coolant flow channel. The aim of this study is to investigate the temperature characteristics and power performance affected by the inlet coolant condition in a massive PEMFC stack and establish a correlation of the temperature uniformity with the affected inlet coolant temperature for thermal management and power performance improvements in PEMFCs. The power density of a massive PEMFC stack with an active area of 326 cm 2 (302 mm × 108 mm) of the designed stack cells with a coolant flow channel were experimentally evaluated, and the thermal characteristics were also analyzed using monitored temperatures inside specific stack cells by considering the different inlet coolant temperatures of 50 °C, 60 °C and 70 °C. It was found that the stack had the greatest power performance and minimum temperature increment of the inlet coolant at a temperature of 70 °C. The water phase transition heat transfer inside the stack was found to play a significant role in the thermal balance. The temperature distribution of the stack cell had a symmetrical convex curve from the center to the margin. The temperature gradient of the stack cell along the coolant flow direction was introduced to characterize the temperature uniformity. The linear development between the temperature gradient and the current density was determined adequately using a curve fitting. In addition, a lower fitting linear slope was obtained for a higher inlet coolant temperature, and this signified that a higher inlet coolant temperature could improve the temperature uniformity and power performance of PEMFCs.

An experimental study for optimizing the energy efficiency of a proton exchange membrane fuel cell with an open-cathode

Experimental study on the dynamic response of voltage and temperature of an open-cathode air-cooled proton exchange membrane fuel cell

Influence of cathode air supply mode on the performance of an open cathode air-cooled proton exchange membrane fuel cell stack

Experimental Investigation on the Open Cathode Air-Cooled Proton Exchange Membrane Fuel Cells: Optimum Operating Parameters and Control Strategies

Comprehensive performance assessment and multi-objective optimization of high-power proton exchange membrane fuel cell system under variable load

Optimal operating conditions to maximize the net power of polymer electrolyte membrane fuel cells: The stack-system interface of a commercial 18 kW module

Control-oriented Modeling and Exploration of Hygrothermal Characteristics of Air-Cooled Proton Exchange Membrane Fuel Cell

Experimental study of the thermal and power performances of a proton exchange membrane fuel cell stack affected by the coolant temperature

Investigation of non-uniform temperature distribution in air-cooled proton exchange membrane fuel cells with multizone temperature measurement

Thermal characteristics of an air‐cooled open‐cathode proton exchange membrane fuel cell stack via numerical investigation

Air flow and pressure optimization for air supply in proton exchange membrane fuel cell system

Experimental study on the thermal management of an open-cathode air-cooled proton exchange membrane fuel cell stack with ultra-thin metal bipolar plates

Integrating Full Fan Morphology and Configuration in Three-Dimensional Simulation of Air-Cooled Proton Exchange Membrane Fuel Cell Stack

Operating Performance and Energy Flow Modeling for a Hundred-Kilowatt Proton Exchange Membrane Fuel Cell Stack Test System

Experimental investigation of self-regulating capability of open-cathode PEMFC under different fan working conditions

Optimal performance and modeling study of air-cooled proton exchange membrane fuel cell with various bipolar plate structure

Air and H2 feed systems optimization for open-cathode proton exchange membrane fuel cells

Improved flow field design for air-cooled proton exchange membrane fuel cells

Recent advances in heat and water management of forced-convection open-cathode proton exchange membrane fuel cells

Fan selection and stack design for open-cathode polymer electrolyte fuel cell stacks

Experimental Analysis of Optimal Performance for a 5 Kw PEMFC System