Abstract:The micellization of a polystyrene-b-poly(dimethylsiloxane) (PS-b-PDMS) diblock copolymer with the number-average molecular weights (M-n) of 193 000 g/mol for PS block and 39 000 g/mol for PDMS block and the glass transition behavior of the PS blocks in the cores of collapsed dry micelles with PDMS tethered coronae were studied. A range of micelle morphologies was observed by varying the micellization conditions and varying the ratio of the methylene chloride (MC) solvent and the n-dodecane (D) selective nonsolvent. MC is a solvent for both of the blocks, but D is a selective solvent for only the PDMS block. After completely removing the solvents below the glass transition temperature (T-g) of the initially solvated PS blocks in MC via extraction and vacuum-drying, the collapsed dry micelles, which were originally spheres and cylinders, became "tablets" or "ribbons". The diameters of the "tablets" and widths of the "ribbons" were approximately 50 and 100 nm, respectively. The thicknesses of these textures ranged from 20 to 40 nm. The PS block cores of the dried micelles exhibited a Tg very close to that of the homo-PS bulk samples with the same M-n. However, for a broad temperature range below the T-g(PS), the collapsed dry micelles possessed heat capacity (C-p) values higher than the addition scheme calculated Cp based on PS and PDMS in their solid and liquid bulk states; whereas the C-p values of the liquid state above the T-g(PS) fit well with the calculated data. These observations support the idea of PS interface layers with mobility induced by the liquid PDMS coronae such that only the inner cores of the PS blocks were in the glassy state. In a temperature region between 0 and 50 degreesC, the lower limit of the interface thickness (i.e., assuming that the mobile PS layers possessed the same mobility as the PS liquid) was estimated to be approximately 2 nm for the collapsed dry micelles. The interface thickness slightly increased with increasing temperature.

Glass Transition Temperature of Polystyrene Microparticles

Glass Transition of Expanded Polystyrene Coils

Glass Transition of Atactic Polystyrene with Less Chain Entanglements

Glass Transition Behavior of Polystyrene Blocks in the Cores of Collapsed Dry Micelles Tethered by Poly(Dimethylsiloxane) Coronae in a PS-b-PDMS Diblock Copolymer

Influence of Entanglements on Glass Transition of Atactic Polystyrene

The Glass Transition Temperature of Poly(Phenylene Sulfide) with Various Crystallinities

Effects of molecular weight and interaction parameter on the glass transition temperature of polystyrene mixtures and its blends with polystyrene/poly (2,6-dimethyl-p-phenylene oxide)

Diffusion Behavior of Polystyrene/Poly(2,6-dimethyl-1,4-phenylene Oxide) (PS/PPO) Nanoparticles Mixture: Diffusion Mechanism for Liquid PS and Glassy PPO

SOLID-SOLID TRANSITION AT THE LOWER TEMPERATURE THAN T(G) FOR EXPANDED COILS OF POLYSTYRENE

Low-Temperature Features of the Micromechanical Properties of Polystyrene

T-g Confinement Effect of Random Copolymers of 4-Tert-butylstyrene and 4-Acetoxystyrene with Different Compositions

Thermodynamic Nature of Monodisperse Polystyrene in Mixed Solvent of Cyclohexane and Antisolvent Carbon Dioxide Using Synchrotron Small-Angle X-ray Scattering

Crystallization Behavior of Single or Pauci Chain Aggregates of Isotactic Polystyrene

Enthalpy Relaxation Near the Glass Transition of Polystyrenes with Controlled Interchain Proximity

Vitrification of polymer solutions as a function of solvent quality, analyzed via vapor pressures

Effects of chain ends and densities on the glass transition of polymer thin films probed by linear and cyclic polystyrene

Chain Conformation Change Upon Heating For Pauci-Chain Polystyrene Microsphere Made By Microemulsion Polymerization

Optical Imaging of the Molecular Mobility of Single Polystyrene Nanospheres

Investigation of liquid-liquid transition process in atactic polystyrene by means of thermally stimulated depolarization current

Micellization Temperature and Pressure for Polystyrene-Block-Polyisoprene in Subcritical and Supercritical Propane

Polystyrene-Block-Poly(Ethylene Oxide) Reverse Micelles And Their Temperature-Driven Morphological Transitions In Organic Solvents