Abstract:Multilayered insulation composites are characterized by their light weight, low thermal conductivity (TC), and good wave permeability and are widely used as heat-insulating materials in aerospace engineering. The existing direct measurement standards and equipment are not applicable in high-temperature, high-radiation, and low-pressure environments for materials whose thermal conductivities are similar to that of air. Moreover, the thermal responses of a multilayered insulation composite to the same boundary conditions resulting from different operation environments are different as a result of its wave permeability and spectral selectivity. The effective TCs are different in different operation environments. There is inevitably a non-negligible thermal contact conductance (TCC) between the individual layers. Thus, it is important to measure the effective TC of a multilayered insulation composite under normal working conditions in different operating environments for the thermal design of the insulation layer. In this study, an indirect measurement strategy based on inverse problem analysis was proposed to simultaneously estimate the TC and TCC of a multilayered insulation composite. The conjugate gradient method was used for the parameter and function estimations of the TC and TCC. The accuracy and robustness of the proposed method were verified numerically and experimentally. The results of a heat-shielding experiment showed no more than a 2.4% deviation for the estimated TC and 11.5% deviation between the measured and estimated temperatures. This method may offer a strategy to measure the thermophysical properties of multilayered insulation composites in an operational environment for aerospace engineering. It can improve the TC measurement accuracy and provide the basis of the physical properties for the thermal insulation design of multilayered insulation composites for use in various operation environments.

Measurement of the Thermal Contact Resistance Between Two-Layer Complex Mediums

Thermal conductivity measurement of phase-change material near melting point based on perturbation method

A laser interferometric measurement on the melt film thickness during close-contact melting on an isothermally-heated horizontal plate

Measurement of the Thermal Transport Properties of Dielectric Thin Films Using the Micro-Raman Method

Quantitative Measurement of the Thermal Contact Resistance between a Glass Microsphere and a Plate

Reverse Identification Method for Simultaneous Estimation of Thermal Conductivity and Thermal Contact Conductance of Multilayered Composites

Experimental Investigation of High Temperature Thermal Contact Resistance of Thin Disk Samples Using Infrared Camera in Vacuum Condition

Measurement Techniques for Thermal Conductivity and Interfacial Thermal Conductance of Bulk and Thin Film Materials

A simple setup to test thermal contact resistance between interfaces of two contacted solid materials

An Experimental Investigation on Thermal Contact Resistance Across Metal Contact Interfaces

Numerical study of thermal contact resistance considering spots and gap conduction effects

Thermal contact resistance on cylindrical flux channel with high contact ratio

Research Progress of Thermal Contact Resistance

The Effect of Interface Resistances on Thermal Wave Propagation in Multi-Layered Samples

A Multi-Block Lattice Boltzmann Method for the Thermal Contact Resistance at the Interface of Two Solids

Measurements of Thermal Resistance Across Buried Interfaces with Frequency-Domain Thermoreflectance and Microscale Confinement

Measuring Thermal Contact Resistance Across Solid and Liquid Interface Mediums by Thermal Imaging Technique: Applications on Bearing Steel

A High-Precision Instrumentation of Measuring Thermal Contact Resistance Using Reversible Heat Flux

Simultaneous Measurement of Thermal Conductivity and Volumetric Heat Capacity of Thermal Interface Materials Using Thermoreflectance

Re-estimation of thermal contact resistance considering near-field thermal radiation effect