Abstract:We present an innovative contactless method suitable to study in-plane thermal transport based on beam-offset frequency-domain thermoreflectance using a one-dimensional heat source with uniform power distribution. Using a one-dimensional heat source provides a number of advantages as compared to point-like heat sources, as typically used in time- and frequency-domain thermoreflectance experiments, just to name a few: (i) it leads to a slower spatial decay of the temperature field in the direction perpendicular to the line-shaped heat source, allowing to probe the temperature field at larger distances from the heater, hence, enhancing the sensitivity to in-plane thermal transport; (ii) the frequency range of interest is typically < 100 kHz. This rather low frequency range is convenient regarding the cost of the required excitation laser system but, most importantly, it allows the study of materials without the presence of a metallic transducer with almost no influence of the finite optical penetration depth of the pump and probe beams on the thermal phase lag, which arises from the large thermal penetration depth imposed by the used frequency range. We also show that for the case of a harmonic thermal excitation source, the phase lag between the thermal excitation and thermal response of the sample exhibits a linear dependence with their spatial offset, where the slope is proportional to the inverse of the thermal diffusivity of the material. We demonstrate the applicability of this method to the cases of: (i) suspended thin films of Si and PDPP4T, (ii) Bi bulk samples, and (iii) Si, glass, and highly-oriented pyrollitic graphite (HOPG) bulk samples with a thin metallic transducer. Finally, we also show that it is possible to study in-plane heat transport on substrates with rather low thermal diffusivity, e.g., glass, even using a metallic transducer.

The Effect of Interface Resistances on Thermal Wave Propagation in Multi-Layered Samples

Numerical Analysis of Thermal Response of Mid-Infrared High Reflectance Coating under Different Laser Irradiation Angles

Transient and Steady-State Temperature Rise in Three-Dimensional Anisotropic Layered Structures in Pump-Probe Thermoreflectance Experiments

Modulation of the Time-Domain Reflectance Signal Induced by Thermal Transport and Acoustic Waves in Multilayered Structure

Thermal Model for Time-Domain Thermoreflectance Experiments in a Laser Flash Geometry

Analysis of Dual-Phase-lag Thermal Behaviour in Layered Films with Temperature-Dependent Interface Thermal Resistance

Transient Thermal Grating Measurements and FEM Calculations of Thermoelastic Theory for Characterizing Multilayered Thin Films

A Model of the Control Problem of the Thermal Effect of a Laser Beam on a Two-Layer Biomaterial

Analytical model for thermal boundary conductance based on elastic wave theory

RAPID TRANSIENT HEAT CONDUCTION IN MULTILAYER MATERIALS WITH PULSED HEATING BOUNDARY

In-plane thermal diffusivity determination using beam-offset frequency-domain thermoreflectance with a one-dimensional optical heat source

Analysis of Thermal Behavior in Multi-Layer Metal Thin Films Based on Hyperbolic Two-Step Model

Modeling for Laser-Induced Surface Thermal Lens in Semiconductors

Theoretical Analysis of Thermal Response in Biological Skin Tissue Subjected to Multiple Laser Beams

Prediction and Measurement of Thermal Transport Across Interfaces Between Semiconductor and Adjacent Layers

In-plane Interfacial Phonon Transport Through Multi-Layer Thin Films by Theoretical Analyses and Monte Carlo Simulations

Investigation and comparison on the interaction of laser and bio-tissue based on two classical models, the beam broaden model and diffusion approximation equation model, theoretically and experimentally

Nonlinear Behavior of Thermal Lagging in Laser-Irradiated Layered Tissue

Effect of interfacial roughness on thermal boundary conductance: An elastic wave model using the Kirchhoff approximation

Comprehensive Study of Thermal Transport and Coherent Acoustic-Phonon Wave Propagation in Thin Metal Film–Substrate by Applying Picosecond Laser Pump–Probe Method

Theoretical Study of Transient Thermal Conduction and Temperature Distribution Generated by Pulsed Laser