Abstract:The metallurgical properties of blast furnace slag changed when high alumina iron ore was used extensively due to the resulting changes of the molten slag microstructure. In the study, based on typical CaO–MgO–SiO2–Al2O3 slag systems with different w(Al2O3) content, molecular dynamics simulation was used to calculate the microstructural properties of particles in the high-temperature slag system, such as bond length, partial radial distribution function, coordination numbers, and diffusion coefficient. In addition, X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, and 27Al solid-state magic angle spinning nuclear magnetic resonance (27Al SS MAS NMR) were used to detect and analyze the samples. The comprehensive calculations and experimental results show that increasing w(Al2O3) can enhance the structural stability of each ion pair, and the strength of the structural stability is such that Si–O > Al–O > Mg–O > Ca–O. The self-diffusion coefficients are as follows: Mg2+ > Ca2+ > Al3+ > Si4+, which leads to the transformation of the [SiO4]4−(Q0), [Si2O7]6−(Q1) and [Si2O6]4−(Q2) structural units to [Si2O5]2−(Q3). The degree of polymerization of slag increased as well as the stability of the structural units. Moreover, the coordination of Al will change from the [AlO6]9−octahedral structure of six-coordinated Al to the [AlO5]7−pentahedral structure of five-coordinated Al and the [AlO4]5−tetrahedral structure of four-coordinated Al. It was also found that the content of non-bridge oxygen in the whole slag system decreased continuously, leading to the increasing degree of polymerization of slag, and the experimental results were consistent with the molecular dynamics calculation.

Determination of 13 Components in Slag by X-ray Fluorescence Spectrometry

Determination of eight components in converter slag by X-ray fluorescence spectrometry

Effect of Al2O3 on the Molten Slag Microstructure Information by Molecular Dynamics Simulation and Experimental Analysis

ICP-AES Determination of 5 Chemical Components in Chromium Ores

Developing an Indexing Methodology for Estimating the Reactivity of Slag from Different Sources Use in Alkali-Activated Materials

Determination of Fe3O4 Content and Total Nonhydraulic Minerals in Steel Slag

Effect of Al2o3 Addition on the Precipitated Phase Transformation in Ti-Bearing Blast Furnace Slags

Application of X-ray fluorescence spectrometry in catalyst composition determination without standard

Fluoride vaporization and crystallization of CaF2–CaO–Al2O3–(La2O3) slag for vacuum electroslag remelting

Qualitative, Quantitative and Mechanism Research of Volatiles in the Most Commonly Used CaO–SiO2–CaF2–Na2Ο Slag During Casting Process

Determination of Iron Content in Float Glass

Structural Characteristics of CaO-SiO2-Al2O3-FeO Slag with Various FeO Contents Based on Molecular Dynamics Simulations

Quantitative phase analysis of the calcium silicate slag as the residue of extracting alumina from high-alumina fly ash

Investigation on microstructure and its transformation mechanisms of B2O3-SiO2-Al2O3-CaO brazing flux system

Effect of unmelted lime on the element distribution behavior on a CaO-SiO2-MgO-Al2O3-FeO-CaF2(-Cr2O3) slag

Experimental Investigation of Slag Melting Points Influenced by Additional Chemical Components

Assessing Magnesia Effect on Preparing Refractory Materials from Ferrochromium Slag

Mineralogical determination and geo-chemical modeling of chromium release from AOD slag: Distribution and leachability aspects

Numerical Investigation of Basic Oxygen Furnace Slag Modification with Gas Bottom-Blowing and SiO2 Modifier

Effect of Cr2O3 on Physicochemical Properties of CaO-SiO2-FetO Slags during BOF Smelting Process of Chromium-Bearing Iron

Multimodal spectroscopy and molecular dynamic simulations to understand redox-chemistry and compound formation in pyrometallurgical slags: example of manganese oxidation state with respect to lithium recycling