Abstract:The silicon carbide (SiC) devices have faster switching speed than that of the conventional silicon (Si) devices, which however may cause excessive device voltage overshoot. Larger gate resistance can help to restrain the overshoot, it however slows down the switching speed and increases switching losses. There are other methods that can mitigate the voltage overshoot, e.g., using low-inductance busbars, adding snubber circuits, etc. In this article, the busbar design for a 250-kW SiC three-level T-type inverter is investigated. The current commutation loops (CCLs) are first analyzed using a single-phase equivalent circuit. Then the detailed busbar design methods, especially a 3-D busbar design concept, are proposed to select the optimal stacking order for the multilayer laminated busbar and to address constraints posed by the physical terminal arrangements of SiC modules and dc-link capacitors. The stray inductance in each CCL is extracted via a finite element analysis and validated on the actual inverter busbar prototypes using an impedance analyzer. To further minimize the busbar stray inductance, a hybrid busbar structure with printed circuit board based buffer circuit using high-frequency decoupling capacitors is designed and evaluated in this article. Finally, the effectiveness of the designed busbars as well as the buffer circuit are validated using experimental studies.

Configuration of Low Inductive Laminated Bus Bar in 750 Kva NPC Three-level Universal Converter Module of High Power Density

Development of a compact 750KVA three-phase NPC three-level universal inverter module with specifically designed busbar

Study And Design Of Noninductive Bus Bar For High Power Switching Converter

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

Design of a 200kVA Soft-switching IGBT Three-phase Inverter

Methodology of Low Inductance Busbar Design for Three-Level Converters

Study On Planar Busbar Regarding Stray Inductance Minimization And Oscillation Suppression For High Power Converter

Engineering Design for Structure and Bus Bar of 1.2MV·A Hybrid Clamped Five-Level Converter Module

Busbar Optimization Design for High Power Converters

Optimization of Laminated Busbar for Three-Level NPC Topology Using SiC Module

Optimized Design of Laminated Busbar for Large-Capacity Back-to-Back Converters

Engineering design for structure and bus bar of 1.2MVA hybrid clamped five-level converter module

Busbar Design and Optimization for Voltage Overshoot Mitigation of a Silicon Carbide High-Power Three-Phase T-Type Inverter

The large-size low-stray-parameter planar bus bar for high power IGBT-based inverters

Optimal Busbar Design for the Press-Packed IGBT-Based Modular Multilevel Converter Submodule Considering Both Normal and Fault Ride-Through Conditions

DC-Link Busbar Network Design and Evaluation Method for the Large-Capacity Power Electronic Converter

Laminated busbar design and stray parameter analysis of three-level converter based on HVIGBT series connection

Design, Simulation and Analysis of the Low Stray Inductance Bus Bar for Voltage Source Inverters

Study on DC Busbar Structure Considering Stray Inductance for the Back-to-back IGBT-based Converter

Modeling of Busbars in High Power Neutral Point Clamped Three-Level Inverters

Low stray inductance bus bar design and construction for good EMC performance in power electronic circuits