Abstract:The reduction of nitric oxide using ammonia combined with methane and pulverized coal additives has been studied in a drop tube furnace reactor. Simulated flue gas with 1000 ppm NO(x) and 3.4% excess oxygen was generated by cylinder gas. Experiments were performed in the temperature range of 700-1200 degrees C to investigate the effects of additives on the DeNO(x) performance. Subsequently, a kinetic mechanism was modified and validated based on experimental results, and a computational kinetic modeling with CHEMKIN was conducted to analyze the secondary pollutants. For both methane and pulverized coal additives, the temperature window is shifted towards lower temperatures. The appropriate reaction temperature is shifted to about 900 and 800 degrees C, respectively with 1000 ppm methane and 0.051 g min(-1) pulverized lignite coal. The addition of methane and pulverized coal widens the temperature window towards lower temperature suggesting a low temperature application of the process. Furthermore, selective non-catalytic reduction (SNCR) reaction rate is accelerated evidently with additives and the residence time to complete the reaction is shortened distinctly. NO(x) reduction efficiency with 80% is achieved in about 0.3s without additive at 1000 degrees C. However, it is achieved in only about 0.2s with 100 ppm methane as additive, and only 0.07 and 0.05s are needed respectively for the cases of 500 and 1000 ppm methane. The modified kinetic modeling agrees well with the experimental results and reveals additional information about the process. Investigation on the byproducts where NO(2) and N(2)O were analyzed by modeling and the others were investigated by experimental means indicates that emissions would not increase with methane and pulverized coal additions in SNCR process and the efficacious temperature range of SNCR reaction is widened approximately with 100 degrees C.

Experimental Study and Mechanism Analysis on Selective Non-Catalytic Reduction Reactions

Experimental and Modeling Study on the Mechanism and Sensitive Parameters of the Thermal DeNOx Process

Experimental and Modeling Study on the Influence of H2 Addition on Selective Non-catalytic Reduction Process

Tailoring the Proceeding of the NH3-SCO and NH3-SCR Reactions over FeOx Catalysts by Modifying with NbOx

MODELING AND EXPERIMENTAL STUDY ON NO_x REDUCTION IN FURNACE WITH AMMONIA INJECTION

Experimental Investigations of Enhanced Selective Non-catalytic Reduction Reaction with Methane

Effects of CO Content on Selective Non-Catalytic Reduction of NOx

Investigation on Effects of Water Vapor on Selective Non-Catalytic Reduction of NO_x

In Situ DRIFTS Studies of NH3-SCR Mechanism over V2O5-CeO2/TiO2-ZrO2 Catalysts for Selective Catalytic Reduction of NOx

Experimental and Modeling Study of the Effect of CH(4) and Pulverized Coal on Selective Non-Catalytic Reduction Process.

Analysis of ammonia combustion for decarbonization followed by selective non-catalytic reduction of nitrogen oxides

Reaction Characteristics of NOx and N2O in Selective Non-Catalytic Reduction Using Various Reducing Agents and Additives

Mechanism Validation and Analysis of the Selective Non-catalytic Reduction Reaction with Methane Additive

Numerical Investigation on Promoting Selective Non-catalytic Reduction with Methane Additive by Computational Fluid Dynamics

Investigation on Effects of Na2CO3 on Selective Non-Catalytic Reduction of NOx

Experimental Study on NOx Reduction by Nitrogen Agents and Pyrolysis Characteristic of Nitrogen Agents

Effects of Light Coal Volatiles on Selective Non-Catalytic Reduction Reactions

Experimental and Kinetic Study on the Influence of Iron Oxide on the Selective Noncatalytic Reduction Deno(X) Process

Experimental Investigation on N2O Formation During the Selective Catalytic Reduction of NOx with NH3 over Cu-SSZ-13

An experimental and modelling study of the Selective Non-Catalytic Reduction (SNCR) of NOx and NH3 in a cyclone reactor

Effect of Methane and Temperature on NO Removal Using by the Selective Non-Catalytic Reduction