Abstract:Indium is acknowledged as a preferred material for micro-light-emitting diodes (micro-LEDs) flip-chip bonding within the industry, due to its favorable economic characteristics and low melting point. However, indium bumps fabricated via photolithography and thermal evaporation often exhibit irregular shapes and varying heights, and they readily oxidize in air to form a tightly adhered oxide layer (In2O3), leading to flip-chip bonding failures and blind pixels. The reflow process can not only remove the oxide layer but also enhance bump uniformity. Nevertheless, literature on indium reflow predominantly focuses on planar substrates, with limited studies on high-resolution micro-LED chips for flip-chip bonding. This paper details the preparation of micro-LED chips with a pixel density (pixel per inch, PPI) of 3175. An indium bump array with a diameter of approximately 5 μm was prepared on the micro-LED chips using thermal evaporation technology. The influence of reflow time and temperature on indium bumps was thoroughly investigated by the formic acid reflow process, revealing that under the conditions of 270 °C and 180 s, the indium bumps with a narrower size distribution could be reflowed into spherical shapes on the micro-LED structure. Furthermore, an inversely proportional relationship was discovered between mesa/metal layer height and indium bump growth, which influenced the reflow effect. Ultimately, micro-LED chips were integrated with si complementary metal–oxide–semiconductor (CMOS) driver chips through flip-chip bonding technology, resulting in the successful functioning of the devices.

Fabrication of in Bump for 128×128 QW Infrared Photodetector Array

Design Realization and Characterization of A Position Sensitive Detector for Fast Optical Measurement

Indium-Based Micro-Bump Array Fabrication Technology with Added Pre-Reflow Wet Etching and Annealing

A High-resolution Colloidal Quantum Dot Imager by Monolithic Integration

Fabrication and Characterization of a New Type 4×4 Arrayed Position-Sensitive Detector

128 X 128 Sw/Mw Two-Color Hgcdte Irfpas

Indium Bump Array Fabrication on Small Cmos Circuit for Flip-Chip Bonding

Development of a High Performance 1280×1024 InGaAs SWIR FPA Detector at Room Temperature

Development Of Infrared Fpa Using Bimaterial Microcantilever Arrays

128×128 Infrared Focal Plane Arrays Based on Type-II InAs/GaSb Superlattice

Imaging of the Mid-Infrared Focal Plane Array with a Modified Read-Out Circuit.

Fabrication and Reflow of Indium Bumps for Active-Matrix Micro-LED Display of 3175 PPI

A Junction-Level Optoelectronic Characterization of Etching-Induced Damage for Third-Generation HgCdTe Infrared Focal-Plane Array Photodetectors

Thin-Film Quantum Dot Photodiode for Monolithic Infrared Image Sensors

Fabrication of a 1024 × 1024 Format Long Wavelength Infrared Focal Plane Array Based on Type-Ii Superlattice and Barrier Enhanced Structure

Fabrication and performances of arsenic-doped HgCdTe long-wavelength infrared photodiode arrays

Surface Micromachined Cantilever Arrays for Infrared Imaging

A Design of Readout Circuit for 384&#x00d7;288 Uncooled Microbolometer Infrared Focal Plane Array

Ge Quantum Dot Infrared Photo-Detector

Fabrication of a Periodic Inverse Micropyramid (PIMP)‐Si/In2Se3 Heterojunction Photodetector Array for RGB‐IR Image Sensing Application

Wafer-Level Vacuum Packaging for an Optical Readout Bi-Material Cantilever Infrared Fpa