Abstract:Fluorinated self-assembled monolayer (F-SAM) surfaces comprised of CF3(CF2)7(CH2)2S- groups bound to a gold substrate were modified by deposition of mass-selected polyatomic ions at collision energies of ∼10 eV. The modified material was characterized in situ by low-energy ion bombardment and by independent high-resolution time-of-flight secondary ion mass spectrometry (TOF-SIMS) analysis. Modification of F-SAM surfaces using hyperthermal (CH3)2SiNCS+ (mz 116) and (CH3)3SiOSi(CH3)2 (mz 147) projectile ion beams incorporated the intact projectile ions mz 116 and mlz 147, respectively, which were released upon subsequent 60 eV ⊎ sputtering. In addition to simple cases of soft landing of intact ions into a surface, two related soft landing channels, dissociative soft landing and reactive soft landing, are also identified. Surfaces modified by prolonged exposure to 35CICH2(CH3)2SiOSi(CH3)2+ (mz 181) and its isotopic variant 37CICH2(CH3)2SiOSi(CH3)2+ (mz 183), yielded only fragment ions derived from the projectile ions, primarily C3H10OSi235Cl+ (mz 153) and C3H10OSi237Cl+ (mz 155) upon ⊎ sputtering as well as in the 15 keV Ga+TOF-SIMS spectra. In these cases, facile fragmentation occurs upon initial ion impact with the surface, the fragment ion being trapped at the interface in an overall process which is described as dissociative soft landing. Consistent with this, the fragment ions C3H10OSi235CI+ (mz 153) and C3H10OSi237Cl+ (mz 155) generated as such in the ion source were deposited without fragmentation and subsequently released intact by 60 eV ⊎ sputtering. In the cases of some projectiles, such as protonated 2,4,6-trimethylpyridine, the sputtered ions released from the modified surface included chemically transformed products due to reaction of the projectile ion at the surface. Such reactive soft landing processes occur by ion/molecule reactions at the interface, although details of their mechanism and its timing have not been elucidated. The extent and nature of surface modification is controlled by choice of the total ion dose, the projectile ion and its energy. Total ion doses used in these experiments typically corresponded to ∼7% of a monolayer; however, inefficiencies in deposition mean that the actual surface coverages achieved are much lower. For a series of pyridine ions, correlations are evident between successful soft landing and the steric bulk of the projectile ion. It is suggested that the bulky groups facilitate energy loss by the projectile as it moves into the SAM surface and subsequently assist in its trapping there. Ex situ TOF-SIMS analysis and in situ sputtering using projectile ions with different recombination energies provide evidence that the ions deposited into the F-SAM surface are present in the matrix as isolated charged species, a result which is further supported by thermal desorption experiments. The modified surfaces are stable in both air and vacuum for several hours, although the trapped ion signal slowly decreases with time. The present method of surface modification appears to represent a new technique for producing long-lived metastable structures by allowing trapping of unusual and chemically reactive species at interfaces.

Growth Mechanisms of Fluoroalkyltrlchlorosilane Self-Assembled Monolayers on the Magnetic Head Surface

Preparation and Characterization of Fluoroalkylsilane Self-Assembled Monolayers on Magnetic Head Surfaces

Growth of Self-Assembled Monolayer on Tetrahedral Amorphous Carbon Film Coated Magnetic Head

Research on the Preparation, Characterization and Tribological Properties of Ultra-Thin Self-Assembled Monolayers on the Magnetic Head Surface

Electrochemical Studies on Self-Assembled Monolayer (sam) Upon Exposure to Anionic Surfactants: Pfoa, Pfos, Sds and Sdbs

Electrochemical Proof of Fluorophilic Interaction among Fluoro‐Carbon Chains

Friction and Wear Studies of Octadecyltrichlorosilane SAM on Silicon

The Growth and Superhydrophobicity of a Perfluorocarbon Nanoneedle Array on an SiO/sub 2/ Surface

Preparation and Tribological Behaviors of an Amide-Containing Stratified Self-Assembled Monolayers on Silicon Surface

Characterization of A Homogeneously Mixed Octyltriethoxyilane/Octadecyltrichlorosilane Self-Assembled Monolayer and Analysis of Its Formation Mechanism

Preparation and Characterization of 3-Mercaptopropyl Trimethoxysilane Self-Assembled Monolayers

Soft Landing of Polyatomic Ions for Selective Modification of Fluorinated Self-Assembled Monolayer Surfaces

Formation of superhydrophobic polymerized n-octadecylsiloxane nanosheets.

Alkyltrichlorosilane-based self-assembled monolayer films for stiction reduction in silicon micromachines

Improved Hydrophobicity of Vapor Coated Chlorosilane Self Assembled Monolayers Using Evaporative Drying of Solvent and Annealing

Self-Assembled Monolayer Growth of Octanol on Mica: Atomic Force Microscopy and Fourier-Transform Infrared Spectroscopy Studies

Ultralow adhesion and friction of fluoro-hydro alkyne-derived self-assembled monolayers on H-terminated Si(111).

Topographical and Performance Characterization of OTS Self-assembled Monolayer on Chemically Textured Silicon Surfaces

Fluoroalkylsilanes with Embedded Functional Groups as Building Blocks for Environmentally Safer Self-Assembled Monolayers.

OTS Self-Assembled Monolayer on Functionalization Glass and Patterning on Titanium Surface

CHARACTERIZATION OF OCTADECYLTRICHLOROSILANE SELF-ASSEMBLED MULTILAYERS ON PYREX GLASS