Abstract:Cavitation erosion is quite complex, containing corrosion-erosion interaction effect. High temperature oxidization may be aroused after bubble collapse, accompanied by hot gas contacting with the pump component surface. The analysis of the erosion pits can be an effective way to know the mechanism of cavitation erosion. In present paper, the cavitation erosion resistance of carbon steel (ANSI 1020) and alloy steel (ANSI 4135) were tested in an ultrasonic vibration apparatus. By using energy dispersive X-ray spectroscope and three dimensional laser microscope, the chemical composition around erosion pits and the oxidation film structure were analyzed. By using metallographic microscope and scanning electronic microscope, the metallographic structure of specimens (e.g., carbon steel and alloy steel), the nano structured iron oxide and corresponding influence on specimen’s anti-erosion performance were discussed. Based on the comparison between the different tests performed in distilled water and tap water respectively, results can be obtained that erosion rate of carbon steel and alloy steel varies with the component of water which had close correlation to the oxidation effect. Erosion rate of alloy steel 4135 was much lower in distilled water compared to tap water while the difference of carbon steel 1020 was not that large. The remarkable different responses of these two materials had close relationship with oxidation effect. The oxidation effect transferred the original structure of alloy steel surface which had high anti-erosion capability, into newly generated iron oxide structure, which was preferentially to be attacked. The pumping of slightly corrosive fluids frequently leads to erosion-corrosion damage on impellers, and corrosion can further amplify the erosion process.

Quantitative Analysis for Effect of Hydrodynamic Factors on Erosion—Corrosion of Air Cooler

Experimental and Numerical Analysis of the Impact of Corrosion on Pipeline Failure Pressure

Investigation on corrosion behavior of the atmospheric pressure air cooler tubes caused by multiphase flow

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

Erosion-corrosion Failure of REAC Pipes under Multiphase Flow

Corrosion Failure Analysis for Heat Transfer Tube in Quick Cooled Oil-Dilute Steam Heat Exchanger

An Experimental Study on Cavitation Erosion-Corrosion Performance of ANSI 1020 and ANSI 4135 Steel

Analysis on failure tube bundles of domestic air cooler used in hydrocracking unit

Numerical Identification of Critical Erosion Prone Areas in Tube Heat Exchangers

Predicting Erosion-Corrosion Induced by the Interactions Between Multiphase Flow and Structure in Piping System

Numerical Predictions of Uniform CO2 Corrosion in Complex Fluid Domains Using Low Reynolds Number Models

Numerical Investigation of Erosion of Tube Sheet and Tubes of a Shell and Tube Heat Exchanger.

THE EFFECT OF DYNAMIC AND STATIC PURE CORROSION ON QUANTITATIVELY STUDYING THE INTERACTION BETWEEN EROSION AND CORROSION OF MATERIALS

Interaction Between Erosive-Wear and Corrosion of Alloy Materials for Hydroturbine in Hydroelectric Station

Numerical Study of Erosion Phenomena with the Presence of Cavitation at Deflector Jet Servo-Valve

A Fuzzy Appraisement-based Applied Study on High-temperature Corrosion of a Thermal Power Plant

Failure analysis of the collection pipeline at the outlet of air cooler in the distillation column

Numerical Study on Acid Condensation and Corrosion Characteristics of Three-Dimensional Finned Tube Surface

Current Situation and Prospect of Erosion Wear

Effect of Corrosion on Performance of Fin-And-Tube Heat Exchangers with Different Fin Materials

A novel numerical investigation of erosion wear over various 90-degree elbow duct sections