Abstract:The high temperature tensile test of Ti-47.5Al-2.5 V-1.0Cr-0.2Zr alloy was carried out by electronic universal testing machine under the condition of 750–900 °C/10 −5 –10 −3 s −1 . The hot tensile stress-strain curves were analyzed, and the constitutive model under hot tensile conditions was established. The microstructure transformation rule and deformation mechanism during tensile process were determined. The results show that the hot tensile curve is longer in the steady-state flow stage corresponding to lower strain rate and higher tensile temperature, the true stress declines and the elongation at break increases. The constitutive equation was established based on the tensile curve data, and the corresponding thermal activation energy was 310.3 kJ/mol. As the rise of tensile temperature and the decline of strain rate, the proportion about cross-layer fracture in the tensile fracture morphology decreases, the number of dimples increases, more lamellar structures change into recrystallized structures, and the softening effect of the alloy is more obvious. The dislocation deformation mechanism mainly includes the existence of dislocation slip and climb, dislocation intersection and dislocation ring or dislocation network formation. Twinning deformation is also another important mechanism of high temperature tensile deformation of TiAl alloy. Twins are formed in parallel with each other, so that the deformation can be further carried out. The dislocations and twins in the deformed microstructure will provide nucleation conditions for recrystallized grains. The dynamic recrystallization(DRX) grains are preferentially formed around the grain boundary and the vicinity of dislocation and twin is also preferred nucleation site for DRX. The DRX behavior is the main softening mechanism, and DRX size and volume fraction corresponding to lower tensile rate and higher tensile temperature are larger.

Dissociation of Dislocations in Al[sub 67]mn[sub 8]ti[sub 26] Deformed at Ambient and High Temperatures

A Molecular Dynamics Study on Mechanical Performance and Deformation Mechanisms in Nanotwinned NiCo-based Alloys with Nano-Precipitates under High Temperatures

Temperature Effects on Deformation Substructures and Mechanisms of a Ni-based Single Crystal Superalloy

Concentration-Dependent High-Temperature Deformation Mechanism of Hexagonal Close-Packed Ti-Al Alloys

Dislocation formation and twinning from the crack tip in Ni_3Al:molecular dynamics simulations

Dislocation formation and twinning from the crack tip in Ni 3 Al: molecular dynamics simulations

Dislocation Formation and Twinning from the Crack Tip in Ni 3 Al:molecular Dynamics Simulations

The behaviour of 1/2112] superlattice dislocations in polysynthetically twinned crystals of TiAl

Dynamic microstructural evolution of Al-Cu-Li alloys during hot deformation

Study of rate-dependence at elevated temperature for an Al-Cu-Mg alloy

Study on high temperature tensile constitutive behavior and deformation mechanism of Ti-47.5Al-2.5 V-1.0Cr-0.2Zr alloy

Transmission Electron Microscopy Study of the Microstructure and Dislocation Configuration in Al67Co8Ti25

Superlattice Dislocations in Ti-rich Polysynthetically Twinned Crystals of TiAl

Machine Learning Moment Tensor Potential for Modelling Dislocation and Fracture in L1$_0$-TiAl and D0$_{19}$-Ti$_3$Al Alloys

Ti-Ti Bonding in γ-TiAl and f.c.c. Ti

Dissociation of Super-Dislocations and the SISF Energy in Γ-Tial Based Alloy with Nb-doping, As Studied by HRTEM

Low Strain Rate Deformation Study in a Two-Phase TiAl Based Intermetallic Alloy

Dynamic behavior and fracture mode of TiAl intermetallics with different microstructures at elevated temperatures

Sessile dislocations by reactions in NiAl severely deformed at room temperature

Temperature-dependent Mechanical Properties and Fracture Behavior of Directionally Solidified Ti47Al2Cr2Nb Alloy

Investigation on the microstructure evolution and dynamic recrystallization mechanisms of TiAl alloy at elevated temperature