Abstract:The high temperature tensile test of Ti-47.5Al-2.5 V-1.0Cr-0.2Zr alloy was carried out by electronic universal testing machine under the condition of 750–900 °C/10 −5 –10 −3 s −1 . The hot tensile stress-strain curves were analyzed, and the constitutive model under hot tensile conditions was established. The microstructure transformation rule and deformation mechanism during tensile process were determined. The results show that the hot tensile curve is longer in the steady-state flow stage corresponding to lower strain rate and higher tensile temperature, the true stress declines and the elongation at break increases. The constitutive equation was established based on the tensile curve data, and the corresponding thermal activation energy was 310.3 kJ/mol. As the rise of tensile temperature and the decline of strain rate, the proportion about cross-layer fracture in the tensile fracture morphology decreases, the number of dimples increases, more lamellar structures change into recrystallized structures, and the softening effect of the alloy is more obvious. The dislocation deformation mechanism mainly includes the existence of dislocation slip and climb, dislocation intersection and dislocation ring or dislocation network formation. Twinning deformation is also another important mechanism of high temperature tensile deformation of TiAl alloy. Twins are formed in parallel with each other, so that the deformation can be further carried out. The dislocations and twins in the deformed microstructure will provide nucleation conditions for recrystallized grains. The dynamic recrystallization(DRX) grains are preferentially formed around the grain boundary and the vicinity of dislocation and twin is also preferred nucleation site for DRX. The DRX behavior is the main softening mechanism, and DRX size and volume fraction corresponding to lower tensile rate and higher tensile temperature are larger.

Concentration-Dependent High-Temperature Deformation Mechanism of Hexagonal Close-Packed Ti-Al Alloys

Study on high temperature tensile constitutive behavior and deformation mechanism of Ti-47.5Al-2.5 V-1.0Cr-0.2Zr alloy

Microstructural evolution and FCC twinning behavior during hot deformation of high temperature titanium alloy Ti65

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

Deformation Twins and Stacking Faults in an AA5182 Al-Mg Alloy Processed by High Pressure Torsion

Insights into High‐Temperature Uniaxial Compression Deformation Behavior of Ti3AlC2

Evading the strength-ductility trade-off at room temperature and achieving ultrahigh plasticity at 800°C in a TiAl alloy

Temperature Effect on Stacking Fault Energy and Deformation Mechanisms in Titanium and Titanium-aluminium Alloy

Ultrahigh strain hardening in a transformation-induced plasticity and twinning-induced plasticity titanium alloy

Twinning-induced dislocation and coordinated deformation behavior of a high-Nb TiAl alloy during high-cycle fatigue

Mechanical Twinning and Dislocation Slip Multilayered Deformation Microstructures in Β-Type Ti–Mo Base Alloy

Mechanical Properties of the Al3(TiTaZrNbHf) High Entropy Intermetallic Compound: A Molecular Dynamic Study

Investigation on the microstructure evolution and dynamic recrystallization mechanisms of TiAl alloy at elevated temperature

New insights into lamellar and twinning transformations in TiAl/Nb composites with core-shell structure during high temperature annealing

Transportation of Dislocation Plasticity in a Dual-Phase TiMo Alloy

The Plastic Deformation Mechanisms of hcp Single Crystals with Different Orientations: Molecular Dynamics Simulations

The behaviour of 1/2112] superlattice dislocations in polysynthetically twinned crystals of TiAl

Hierarchically heterogeneous strategy for Ti 2 AlC/TiAl composite with superior mechanical properties

The Deformation Mechanism of Low Symmetric Ti-Pt Intermetallic Compounds Containing High Density of Planar Defects

In-situ synchrotron high energy X-ray diffraction study on the deformation mechanisms of D0 19 -α 2 phase during high-temperature compression in a TiAl alloy

High-Ti inducing local Eta-phase transformation and creep-twinning in CoNi-based superalloys