Abstract:The investigation of frictional pressure drops in wire-wrapped bundles at low flow velocities is crucial for thermal-hydraulic studies of sodium-cooled fast reactor cores. This study aims to refine empirical formulas for predicting friction factors in wire-wrapped bundles by addressing their limitations in accurately calculating friction factors during transition regime. By analyzing existing empirical formulas and meticulously observing frictional pressure drop experiments conducted under low-flow conditions that reported in the literature, the study proposes and demonstrates the mechanism of the laminar-to-transitional regime transition in wire-wrapped bundles. Additionally, experimental research was conducted on the frictional pressure drop of a 37-rod wire-wrapped bundle. A novel high-precision differential pressure measurement technique, the photographic liquid column manometer, was employed to enhance frictional pressure drop measurement accuracy. This innovative method achieves a measurement uncertainty of less than 2 Pa within a range of 0 to 300 Pa. The mass flow rate of the fluid was measured and converted to obtain the flow velocity through the assembly, further improving the accuracy of flow velocity measurements. The analysis and experiments reveal that the transition from the laminar to transitional regime does not occur uniformly but initiates locally in certain subchannels before spreading across the assembly as flow velocity increases. Significant increases in the frictional pressure drop occur only after a sufficient number of subchannels have undergone transition. This perspective is supported by extensive existing literature, which report that in assemblies with fewer rod bundles, smaller P/D and H/D values, and constructed from hard metal materials such as stainless steel, the friction factor at the initial stage of the transitional regime shows a significant increase or remains constant with increasing Reynolds number. Under these conditions, the high consistency of the P/D ratio within the assembly causes the fluid to transition within a narrow range of flow velocities, leading to a marked increase in the friction factor with Reynolds number. The research results also indicate that the prediction accuracy of the critical Reynolds number for the laminar-to-transitional flow transition significantly impacts the calculation accuracy of empirical formulas at low flow velocities. Formulas using smaller predicted values of the critical Reynolds number show better agreement between predicted values and the measured results in this study. Therefore, the study recommends adopting smaller critical Reynolds numbers and interpolation indices in empirical formulas to facilitate an early onset and smooth transition of laminar-to-transitional regime behavior in friction factors, thereby improving the accuracy of calculated friction factors.

PRESSURE DROP INVESTIGATION ON LABYRINTH STRUCTURES OF A NOVEL PASSIVE FLOW LIMITER APPLIED TO NUCLEAR HEATING REACTOR

Geometric Optimization of a Novel Passive Flow Limiter for Nuclear Heating Reactors

Effects of the geometrical features of flow paths on the flow behaviour of a multi-stage labyrinth pressure reducing valve throttling components

MHD Pressure Drop Measurement of PbLi Flow in Double-Bended Pipe

Fluid Dynamics Analysis and Optimized Throttling Design of L-shaped Multi-Stage High Pressure Reducing Valve

Numerical Simulation of Flow Distribution in the Lower Plenum of NHR200-II

Experimental Study of a Stoppage Natural Circulation During a Nuclear Heating Reactor LOCA

Experimental Study of the Transient Characteristics of A Natural Circulation Loop under Sbloca

Studies on Source Effect in Experimental Design for Passive Cooling in Large Cavities under LOCA Conditions

Numerical Investigation on Flow Excursion Boundary of A Full Power Natural Circulation Reactor

Scaling Analysis and Design for Integrated Nuclear Heating Reactor Ⅱ Major Loop Test Facility under Single Phase Natural Circulation

Innovative Flow-Resistance Performance in the Single-Phase Natural Circulation Loop and Relevant Experiment Verification

EXPERIMENTAL STUDY ON LOW PRESSURE FLOW INSTABILITY

Design optimization of noise reduction for labyrinth control valve in secondary circuit flow regulation system

Numerical Investigation on Heat Transfer Features of Gas-Cooled Open Lattice Reactor in Normal Operations

Applicability of RANS models and pressure drop in edge subchannels for 19-pin wire-wrapped fuel bundle channel in CiADS

Characterization of the MHD flow and pressure drop in the access ducts of a liquid metal fusion blanket

CFD analysis of thermal-hydraluic behaviors in a LBE cooled 19-pin wire wrapped bundle under porous lumped blockage conditions

Experimental Study on Frictional Pressure Drop Characteristics of Wire-wrapped Bundles in Transition Flow

Numerical Study Of The Gas-Steam Transient Behavior In The Integrated Pressurizer

Pressure Reducing and Loss of Water under SBLOCA at Upper Plenum of Nuclear Heating Reactors