Abstract:In this paper, a high efficiency broadband planar array antenna is developed at X-band for synthetic aperture radar (SAR) on small satellites. The antenna is based on a multi-layer element structure consisting of two dielectric substrates made of Taconic TLY-5 and three copper layers (i.e., the parasitic patch (top layer), the active patch (middle layer), and the ground plane (bottom layer)). The parasitic patch resides on the bottom surface of the upper TLY-5 substrate while the active patch is printed on the top surface of the lower substrate. A Rohacell foam material is sandwiched between the top layer and the middle layer to separate the two dielectric substrates in order to achieve high directivity, wideband, and to keep the antenna weight to a minimum as required by the SAR satellite application. To satisfy the required size of the antenna panel for the small SAR satellite, an asymmetric corporate feeding network (CFN) is designed to feed a 12 × 16 planar array antenna. However, it was determined that the first corporate feed junction at the center of the CFN, where higher amplitudes of the input signal are located, contributes significantly to the leaky wave emission, which degrades the radiation efficiency and increases the sidelobe level. Thus, a suspended microstrip slab, which is simply a wide and long microstrip line, is designed and positioned on the top layer directly above that feed junction to prevent the leaky waves from radiating. The experimental results of the antenna show good agreement with the simulated ones, achieving an impedance bandwidth of 12.4% from 9.01 to 10.20 GHz and a high gain above 28 dBi. The antenna efficiency estimated from the gain and directivity eclipses 51.34%.

A Simple Active Transponder for X-band SAR Satellite Applications

Implementation of a New S-Band Micro-Transponder Based on Software Defined Radio

Multistate Active Control RCS Signature for the Continuous Adjustment Absorber/reflector Transformation Applications.

24-Ghz Biomedical Radar on Flexible Substrate for ISAR Imaging

Feasibility Study: Highly Integrated Chipset Design for Compact Synthetic Aperture Radar Payload on Micro-Satellite

High-Efficiency Broadband Planar Array Antenna with Suspended Microstrip Slab for X-Band SAR Onboard Small Satellites

Tapered Resistive Sheets and FSS Absorber Loading for the Wideband RCS Reduction of the Elliptic Surface at TM Polarization

A Reconfigurable Active Beamforming Array for Biomedical Radar Applications

A $K$ -Band Portable FMCW Radar with Beamforming Array for Short-Range Localization and Vital-Doppler Targets Discrimination

A Low-Power, Ambiguous Synthetic Aperture Radar Concept for Continuous Ship Monitoring

Radically new design of SAR satellite: short vertical antenna approach

SIGNAL ERRORS ANALYSIS OF ACTIVE CALIBRATION VIA TRANSPONDER

Active Metasurface for Broadband Radiation and Integrated Low Radar Cross Section

A 253mw/channel 4TX/4RX Pulsed Chirping Phased-Array Radar TRX in 65nm CMOS for X-band Synthetic-Aperture Radar Imaging

Broadband antenna array for SAR applications

A C-Band GaN Single Chip Front-End for SAR Applications

A 4TX/4RX Pulsed Chirping Phased-Array Radar Transceiver in 65-nm CMOS for X-Band Synthetic Aperture Radar Application

Low In-Band RCS Reconfigurable Metasurface With LP Feed for CP Transmission, LP Reflection, and Simultaneous Transmission-Reflection Modes' Switching

Integrated Design Based Plug-and-Play Small SAR Satellite Project

13.2 A Ku-band 260mW FMCW synthetic aperture radar TRX with 1.48GHz BW in 65nm CMOS for micro-UAVs.

Low RCS Transmitarray Using Phase Controllabe Rasorber