Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

Low RCS Transmitarray Using Phase Controllabe Rasorber

Low RCS Transmitarray Employing Phase Controllable Absorptive Frequency-Selective Transmission Elements

A Wideband Transmission Frequency Selective Surface Rasorber

Enhanced High-gain Antenna Design with Phase-Controlled Frequency Selective Rasorber for LowRCS Performance

Multi-characteristic Integrated Ultra-wideband Frequency Selective Rasorber

Design of a Wideband Absorption Frequency Selective Rasorber Based on Double Lossy Layers

A Wideband Transmission Frequency Selective Surface Rasorber with Low Insertion Loss

A broadband reconfigurable rasorber radome based on AFSR for RCS reduction

Ultralow Scattering and Broadband Metasurface Using Phase Adjustable FSS Elements Embedded With Lumped Resistors

Novel Frequency-Selective Rasorber with Ultrawide Absorption Bandwidth Covering Both the X- and Ku-Bands

A Frequency-Selective Surface Rasorber Based on Four Functional Layers

Low-RCS Reflectarray Antenna Based on Frequency Selective Rasorber

Multistate Active Control RCS Signature for the Continuous Adjustment Absorber/reflector Transformation Applications.

Design of A Low RCS 1 Bit Electronically Reconfigurable Transmitarray Antenna

Miniaturised Frequency Selective Surface‐based Rasorber with Wideband Two‐sided Absorption and Switchable Transmission/reflection Band

Actively Tunable Rasorber with Broadband RCS Reduction and Low Infrared Emissivity.

Tapered Resistive Sheets and FSS Absorber Loading for the Wideband RCS Reduction of the Elliptic Surface at TM Polarization

Ultra-wideband RCS reduction based on reflection cancellation and tunable absorption

Frequency Selective Rasorber with Broadband Transmission Window Using Characteristic Modes Analysis

High-Selectivity Frequency-Selective Rasorber Based on Low-Profile Bandpass Filter

A miniaturized frequency selective rasorber with high selectivity passband and wideband absorption properties