Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

Low RCS Transmitarray Employing Phase Controllable Absorptive Frequency-Selective Transmission Elements

Design of A Low RCS 1 Bit Electronically Reconfigurable Transmitarray Antenna

Enhanced High-gain Antenna Design with Phase-Controlled Frequency Selective Rasorber for LowRCS Performance

Ultra-wideband RCS reduction based on reflection cancellation and tunable absorption

Tapered Resistive Sheets and FSS Absorber Loading for the Wideband RCS Reduction of the Elliptic Surface at TM Polarization

An Absorptive/ Transmissive Frequency Selective Surface Based Low-RCS Microstrip Antenna Array

An Integrated Antenna Array With Broadband, Low-RCS, and High-Gain Characteristics

1 Bit Electronically Reconfigurable Transmitarray Antenna with Out-of-Band Scatter Suppression

Wideband Low RCS Antenna Based on Hybrid Absorptive-Diffusive Frequency Selective Reflector

Tapered Resistive Sheets Loading to the FSS Absorber for the Wide-Angle Monostatic RCS Reduction Applications

Multistate Active Control RCS Signature for the Continuous Adjustment Absorber/reflector Transformation Applications.

Ultralow Scattering and Broadband Metasurface Using Phase Adjustable FSS Elements Embedded With Lumped Resistors

Low In-Band RCS Reconfigurable Metasurface With LP Feed for CP Transmission, LP Reflection, and Simultaneous Transmission-Reflection Modes' Switching

A broadband reconfigurable rasorber radome based on AFSR for RCS reduction

Novel Low-RCS Circularly Polarized Antenna Arrays via Frequency-Selective Absorber

Low-RCS Broadband Phased Array Using Polarization Selective Metamaterial Surface

Broadband Low-RCS Circularly Polarized Antenna Array With Reconfigurable Scattering Patterns

A Design Method for Low-Profile Wide-Angle Scanning Reconfigurable Transmitarray

Design of a Wideband Absorption Frequency Selective Rasorber Based on Double Lossy Layers

A Mesh-Type Ultra-Wideband Low RCS Transmitarray Antenna Based on Spoof Surface Plasmon Polariton

A Wideband Transmission Frequency Selective Surface Rasorber