Abstract:The loss of strength and durability caused by early frost attack is the macro performance of internal microstructure deterioration. Understanding the influence mechanism of early frost attack at the micro level is necessary to avoid or minimize the early frost attack to macro performance. In this study, the influence of early frost attack on the strength, water sorptivity, chloride permeability, and microstructure of cement mortar was investigated. The fresh mortars were pre-cured for 10, 12, 14, and 16 h and then frozen at -10 degrees C for 7 days to simulate an early frost attack. After freezing, the standard curing (20 degrees C) was carried out until the testing. It is found that after standard curing of 28 days, the strength of early-frozen mortar can reach more than 95 % of the 28-day strength of unfrozen mortar. Interestingly, the sorptivity coefficient and total charge passed of earlyfrozen mortar are much higher than the level of unfrozen mortar, and the loss of resistance to water penetration and chloride ion penetration exceeds 20 %, indicating that early frost attack causes more severe damage to the durability than to the strength of mortar. Mercury intrusion porosimetry (MIP) results show that early frost attack can increase the pore volume of >50 nm and coarsen the pores within 10-50 nm. Correspondingly, key pore parameters (critical pore diameter, threshold pore diameter, and tortuosity) that affect the durability of mortar are also negatively affected. Energy dispersive spectroscopy (EDS) analysis also shows that after suffering early frost attack, the interfacial transition zone (ITZ) thickness of mortar is increased from 4 to 10 mu m to 8-13 mu m, and the probability of high Ca/Si ratios (4-10) in the ITZ is also increased. Finally, it is concluded that the coupling effect of pore structure coarsening and ITZ degradation leads to more severe durability loss.

Absorbing Effect of Air Entraining Agent on Early Frost Expansion of Mortar: Calculation Model and Application

RBSM-based Mesoscale Study of Frost Deterioration for Recycled Concrete Considering Air-Entrainment in Old and New Mortar

Effect of waterproof agent on performance of inorganic lightweight aggregate thermal insulating mortar

Change of the Coefficient of Thermal Expansion of Mortar Due to Damage by Freeze Thaw Cycles

STUDY ON WATER ABSORPTION MODEL OF AIR-ENTRAINING CONCRETE UNDER NATURAL CONDITIONS

Both Plasticizing and Air-Entraining Effect on Cement-Based Material Porosity and Durability

Meso-scale mechanical model for mortar deformation under freeze thaw cycles

Study on the Influence of Early Frost Attack on the Performance of Cement Mortar

Estimation of Ice Formation in Mortar Saturated with Sodium Chloride Solutions

Experimental Examination of Electrical Characteristics for Portland Cement Mortar Frost Damage Evaluation

A Thermal-Hydraulic-mechanical Coupling Model for Freezing Process Simulation of Cementitious Materials with Entrained Air Voids

Two‐dimensional Rigid Body Spring Method Based Micro‐mesoscale Study of Mechanical Strengthening/damaging Effects to Concrete by Frost Action

Improved freeze-thaw modification of recycled concrete aggregate originally from frost resistive concrete

Environmental Factors Influencing The Durability Of Concrete Structures In Frost Environments

Effect of the entrained air void on strength and interfacial transition zone of air-entrained mortar

Estimation of Ice Content in Mortar Based on Electrical Measurements under Freeze-Thaw Cycle

Meso-Scale Mechanical Deterioration Of Mortar Subjected To Freeze Thaw Cycles And Sodium Chloride Attack

Influence of Freezing Rate on Cryo-Damage of Cementitious Material

Influence of Aeolian Sand on Capillary Water Absorption of Concrete Under Freeze–Thaw Conditions

Effect of Low Atmospheric Pressure on Air Entrainment in Cement-Based Materials: an On-Site Experimental Study at Different Elevations

Frost Resistance and Microscopic Properties of Recycled Coarse Aggregate Concrete Containing Chemical Admixtures