Abstract:We present a systematic study of the properties of TiN films by varying the deposition conditions in an ultra-high-vacuum reactive magnetron sputtering chamber. By increasing the deposition pressure from 2 to 9 mTorr while keeping a nearly stoichiometric composition of Ti(1-x)N(x) (x=0.5), the film resistivity increases, the dominant crystal orientation changes from (100) to (111), grain boundaries become clearer, and the strong compressive strain changes to weak tensile strain. The TiN films absorb a high concentration of contaminants including hydrogen, carbon, and oxygen when they are exposed to air after deposition. With the target-substrate distance set to 88 mm the contaminant levels increase from ~0.1% to ~10% as the pressure is increased from 2 to 9 mTorr. The contaminant concentrations also correlate with in-plane distance from the center of the substrate and increase by roughly two orders of magnitude as the target-substrate distance is increased from 88 mm to 266 mm. These contaminants are found to strongly influence the properties of TiN films. For instance, the resistivity of stoichiometric films increases by around a factor of 5 as the oxygen content increases from 0.1% to 11%. These results suggest that the sputtered TiN particle energy is critical in determining the TiN film properties, and that it is important to control this energy to obtain high-quality TiN films. Superconducting coplanar waveguide resonators made from a series of nearly stoichiometric films grown at pressures from 2 mTorr to 7 mTorr show an increase in intrinsic quality factor from ~10^4 to ~10^6 as the magnitude of the compressive strain decreases from nearly 3800 MPa to approximately 150 MPa and the oxygen content increases from 0.1% to 8%. The films with a higher oxygen content exhibit lower loss, but the nonuniformity of the oxygen incorporation hinders the use of sputtered TiN in larger circuits.

Microwave Loss of DC Sputtered NbTiN Microstrip Lines

Microwave loss and kinetic inductance of epitaxial TiN films

Studies of BaO-Nd2O3-TiO3 Thin Films by RF Sputter and Its TMLs

Epitaxial titanium nitride microwave resonators: Structural, chemical, electrical, and microwave properties

Superconducting Microstrip Losses at Microwave and Sub-millimeter wavelengths

The effect of niobium thin film structure on losses in superconducting circuits

Etch induced microwave losses in titanium nitride superconducting resonators

Nonlinearity and wideband parametric amplification in an NbTiN microstrip transmission line

Improving magnetic-field resilience of NbTiN planar resonators using a hard-mask fabrication technique

Microwave Properties of Superconducting Atomic-Layer Deposited TiN Films

Magnetic Field Dependent Microwave Losses in Superconducting Niobium Microstrip Resonators

Microwave characterization of tantalum superconducting resonators on silicon substrate with niobium buffer layer

Identifying capacitive and inductive loss in lumped element superconducting hybrid titanium nitride/aluminum resonators

High kinetic inductance NbTiN films for quantum limited travelling wave parametric amplifiers

Sputtered TiN films for superconducting coplanar waveguide resonators

Temperature dependence of microwave losses in lumped-element resonators made from superconducting nanowires with high kinetic inductance

Low Loss Superconducting Titanium Nitride Coplanar Waveguide Resonators

Disentangling superconductor and dielectric microwave losses in submicrometer / interconnects using a multimode microstrip resonator