Abstract:Fouling is a great problem that significantly affects the continuous operation for large-scale radio-frequency (RF) thermal plasma synthesizing nanopowders. In order to eliminate or weaken the phenomenon, numerical simulations based on FLUENT software were founded to investigate the effect of operation parameters, including feeding style of central gas and sheath gas, on plasma torches. It is shown that the tangential feeding style of central gas brings serious negative axial velocity regions, which always forces the synthesized nanopowders to "back-mix", and further leads to the fouling of the quartz tube. Moreover, it is shown that sheath gas should be tangentially fed into the plasma reactor to further eliminate the gas stream's back-mixing. However, when this feeding style is applied, although the negative axial velocity region is decreased, the plasma gas and kinetic energy of the vapor phase near the wall of the plasma reactor are less and lower, respectively; as a result, that plasma flame is more difficult to be arced. A new plasma arcing method by way of feeding gun instead of torch wall was proposed and put in use. The fouling problem has been well solved and plasma arcing is well ensured, and as a result, the experiment on large-scale production of nanopowders can be carried out for 8 h without any interruption, and synthesized Si and Al2O3 nanopowders exhibit good dispersion and sphericity.

A New Method to Produce Superfine and Nano-Sized Fe Powders: Spark Plasma Discharge Process

Research of Superfine Fe Powder Prepared by Spark Plasma Erosion

Controllable Synthesis of Hierarchical Micro/nano Structured FePO4 Particles under Synergistic Effects of Ultrasound Irradiation and Impinging Stream

Synthesis of Fe3O4 powder by a novel arc discharge method

Influence of Electrical Parameter on the Size of Superalloy Powders Prepared by Spark Plasma Discharge Process

Preparation of Nanoparticles with an Environment-Friendly Approach

Scalable Production of Carbon Encapsulated Ni Nanoparticles by Water Arc Discharge: Structural and Magnetic Properties

The Numerical and Experimental Investigation of Particle Size Distribution Produced by an Electrical Discharge Process

The numerical research on the effect of ultrasonic field on metallic powders produced by the ultrasonic-assisted electrical discharge process

Synthesis of small-sized spherical Fe-based amorphous powders with insulating nanolayer from ribbon electrodes

Metallic Powder Synthesized by Ultrasound-Assisted Electrical Discharge: Parametric Optimization-Based Isight Platform and Feasible Micro-fabrication Sintering

An Α-Fe2o3 Powder of Nanosized Particles Via Precursor Dispersion

Modeling and Selection of RF Thermal Plasma Hot-Wall Torch for Large-Scale Production of Nanopowders

Uniformly Dispersed FeO X Atomic Clusters by Pulsed Arc Plasma Deposition: an Efficient Electrocatalyst for Improving the Performance of Li–O 2 Battery

Status-in-art of Preparation and Production of Ultra-fine Copper Powder in China

A review of inorganic particles synthesized through electrical discharge in different dielectric media: from devices, structures and components to applications

Controllable Preparation of Spherical Molybdenum Nano-Powders by One-Step Reduction of APM in Radio Frequency Hydrogen Plasma

Flame synthesis of nanoparticles based on high flux electrostatic atomization burner

Synthesis of Ultra-Fine Iron Powder by Combining the Flame Aerosol Synthesis and Postreduction

Atomization of the Fe-rich MnNiCoCr high-entropy alloy for spherical powder production

Preparation of nano-powder by thermal plasma