Abstract:This article presents a 39 GHz transceiver front-end chipset for 5G multi-input multi-output (MIMO) applications. Each chip includes two variable-gain frequency-conversion channels and can support two simultaneous independent beams, and the chips also integrate a local-oscillator chain and digital module for multi-chip extension and gain-state control. To improve the radio-frequency performance, several circuit-level improvement techniques are proposed for the key building blocks in the front-end system. Furthermore, an advanced low-temperature co-fired ceramic process is developed to package the 39 GHz dual-channel transceiver chipset, and it achieves low packaging loss and high isolation between the two transmitting (TX)/receiving (RX) channels. Both the chip-level and system-in-package (SIP)-level measurements are conducted to demonstrate the performance of the transceiver chipset. The measurement characteristics show that the TX SIP provides 11 dB maximum gain and 10 dBm saturated output power, while the RX SIP achieves 52 dB maximum gain, 5.4 dB noise figure, and 7.2 dBm output 1 dB compression point. Single-channel communication link testing of the transceiver exhibits an error vector magnitude (EVM) of 3.72% and a spectral efficiency of 3.25 bit·s−1·Hz−1 for 64-quadrature amplitude modulation (QAM) modulation and an EVM of 3.76% and spectral efficiency of 3.9 bit·s−1·Hz−1 for 256-QAM modulation over a 1 m distance. Based on the chipset, a 39 GHz multi-beam prototype is also developed to perform the MIMO operation for 5G millimetre wave applications. The over-the-air communication link for one- and two-stream transmission indicates that the multi-beam prototype can cover a 5–150 m distance with comparable throughput.

2.4Ghz/5ghz Wide-Band Receiver in a Wireless Communication System Based on 4&#x00d7;4 MIMO Technology

A 39 GHz Dual-Channel Transceiver Chipset with an Advanced LTCC Package for 5G Multi-Beam MIMO Systems

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

A Fully Integrated 60ghz Four Channel CMOS Receiver with 7ghz Ultra-Wide Bandwidth for IEEE 802.11ad Standard

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS

2×2 MIMO W-band Millimeter Wireless Signal Delivery Employing CMA and MRC Technology

Investigation of Parallel and Quadrature MIMO Antennas with Double-Notched Structure for UWB Applications

A -10.1Dbm IIP3, 0.3-40Ghz Receiver Using Hybrid-Path Band-Selection with Reduced LO Coverage Bandwidth Supporting 480mb/s 4096-QAM and 7.2gb/s 64-QAM Modulation

A Monolithic 3.1-4.8 GHz MB-OFDM UWB Transceiver in 0.18-Μm CMOS

A Design of the Four-transmit Antenna and Multiple-receive System Based on the Technology of MIMO-OFDM

A 28-GHz Beam-Space MIMO RX With Spatial Filtering and Frequency-Division Multiplexing-Based Single-Wire IF Interface

A High-Speed Four-Transmitter Four-Receiver Mimo Ofdm Testbed: Experimental Results and Analyses

A 6.2–9.5 GHz Receiver for Wimedia MB-OFDM and China UWB Standard

A 3.1–4.8 GHz CMOS receiver for MB-OFDM UWB

58.74-Gb/s $2\times2$ MIMO 60-Ghz Optical/Wireless System with Simple Power-Detector Down-Conversion

Design of 28 GHz 64-QAM Digital Receiver

The Research of MIMO-OFDM System in the Fourth Generation Mobile Communication

2 $\times$ 2 MIMO OFDM-RoF System Employing LMS-Based Equalizer with I/Q Imbalance Compensation at 60 GHz

60-GHz optical/wireless MIMO system integrated with optical subcarrier multiplexing and 2x2 wireless communication.

Ultrahigh capacity 2 × 2 MIMO RoF system at 60 GHz employing single-sideband single-carrier modulation

A 29-to-36 GHz 4TX/4RX Dual-stream Phased-array Joint Radar-Communication CMOS Transceiver Supporting Centimeter-level 2D Imaging and 64-QAM OTA Wireless Link

2.4Ghz/5ghz Wide-Band Receiver in a Wireless Communication System Based on 4&amp;#x00d7;4 MIMO Technology