Abstract:An ultra-low power ECG processor ASIC (application specific integrated circuit) with R-wave detection and data compression is presented, which is designed for the long-term implantable cardiac monitoring (ICM) device for arrhythmia diagnosis. An adaptive derivative-based detection algorithm with low computation overhead for potential arrhythmia recording is proposed to detect arrhythmia with the occasional abnormal heart beats. In order to save as much as possible cardiac information with the limited memory size available in the ICM device, a hierarchical data buffer structure is proposed which saves 3 types of data, including the raw ECG data segments of 2 seconds, compressed ECG data segments of 45 seconds, and R-peak values and interval lengths of >2000 beat cycles. A modified swinging-door-trending (SDT) method is proposed for the ECG data compression. The ASIC has been implemented based on fully-customized near-threshold standard cells using the thick-gate transistors in 65-nm CMOS technology for low dynamic power consumption and leakage. The ASIC core occupies a die area of 1.77 mm2. The measured total power is 2.63 μW, which is among the ECG processors with the lowest core power consumption. It exhibits a relatively high positive precision rate (P+) of 99.3% with a sensitivity of 98.2%, in contrast to the similar designs in literature with the same core power consumption level. Also, an ECG data compression ratio (CR) of up to 17.0 has been achieved, with a good trade-off between the compression efficiency and loss.

A Miniature On-Chip Multi-Functional ECG Signal Processor with 30 &#x00b5;w Ultra-Low Power Consumption

An ASIC Solution for Intelligent Electrodes and Active-Cable Used in a Wearable ECG Monitoring System.

A 1.0 V 78 μw Reconfigurable ASIC Embedded in an Intelligent Electrode for Continuous Remote ECG Applications

A Multi-Parameter Bio-Electric ASIC Sensor with Integrated 2-Wire Data Transmission Protocol for Wearable Healthcare System

A 457 nW Near-Threshold Cognitive Multi-Functional ECG Processor for Long-Term Cardiac Monitoring

A 457-Nw Cognitive Multi-Functional ECG Processor

An ECG-on-Chip for Wearable Cardiac Monitoring Devices

An Active-Cable Connected ECG Monitoring System for Ubiquitous Healthcare

Bio-chip ASIC and Printed Flexible Cable on Paper Substrate for Wearable Healthcare Applications

An Ultra-Low Power ECG Acquisition and Monitoring ASIC System for WBAN Applications

Power and Area Efficient Wavelet-Based On-chip ECG Processor for WBAN

A 2.63 μW ECG Processor With Adaptive Arrhythmia Detection and Data Compression for Implantable Cardiac Monitoring Device

Multiple Functional ECG Signal is Processing for Wearable Applications of Long-Term Cardiac Monitoring

A 746 Nw ECG Processor ASIC Based on Ternary Neural Network

A 1.92 Μa Always-on ECG Monitoring Mixed-Signal SoC for Implantable Medical Application.

Signal Processing System-on-chip Design for Biomedical Applications.

An Energy-Efficient Design for ECG Recording and R-Peak Detection Based on Wavelet Transform

A 58 nW ECG ASIC With Motion-Tolerant Heartbeat Timing Extraction for Wearable Cardiovascular Monitoring

A Low Power Qrs Detection Processor With Adaptive Scaling Of Processing Resolution

An Area-Efficient Error-Resilient Ultralow-Power Subthreshold ECG Processor

A Dual-Mode ECG Processor with Difference-Insensitive QRS Detection and Lossless Compression

A Miniature On-Chip Multi-Functional ECG Signal Processor with 30 &amp;#x00b5;w Ultra-Low Power Consumption