Abstract:The vector network analyzer (VNA) has been widely applied in the measurement of microwave devices with wide frequency bandwidths. Particularly, the measurement of the complex reflection coefficients of waveguide devices is its important applications. Due to connecting the devices to be measured to the VNA with a coaxial-to-waveguide adaptor, the systemic error caused by the defect of the coaxial-to-waveguide adaptor will be introduced. For solving the problem, the calibration of the coaxial-to-waveguide adaptor is needed by connecting a series of known standard components to the measurement system. Subsequently, the systemic error can be obtained by analyzing the measurement results of the known standard components. The traditional calibration method uses three standard components, i.e., a load, a short circuit, and an offset short with known phase. However, with the traditional calibration method, the exact location of the short plane is difficult to be determined at the range of millimeter wave frequencies. In this paper, a novel calibration procedure using a matched load and an adjustable shorter with several unspecified phases is proposed to reduce the systemic error caused by the adaptor. The advantage of this method is only to define one shorter plane as reference plane. During the calibration process, the position of the piston is unnecessary to be recorded. More offset shorts are used; more accurate de-embedding effect can be get. The proposed calibration method is especially fitted to the system calibration at the range of millimeter wave frequencies, where the accuracy of the system calibration is very sensitive to the position of standard short plane. The measured results show that the module of corrected S-11 of a shorter is less than 0.1 dB with linear phase delay and the corrected S-11 of a matched load is below -40 dB. The results are much more accurate than the raw readings, 1.3 dB and -15 dB respectively, before the adaptor calibration. It is also shown that the technique is resistant to the error of the adjustable shorter position and is easy to implement.

Cost-Effective Single-Port Measurement Campaign for Test System Calibration

MMIC on-Wafer Test Method Based on Hybrid Balanced and Unbalanced RF Pad Structures

A Simple Over-The-Air Hardware Calibration Procedure In Tdd Systems

A Novel Four-Port Symmetric Probe Calibration Method for On-Wafer S-Parameter Measurement

A Novel Four-Port Calibration Method for High Frequency On-Wafer S-parameter Measurement

A New Self-calibration Method of the Six-port Measurement System

Measurement and calibration of a universal six-port network analyzer

Realization and optimization of calibration based on high accuracy waveguide six-port measurement system

Wireless Cable Testing for MIMO Radios: A Compact and Cost-Effective 5G Radio Performance Test Solution

Design of the Addressable Test Structure for ${S}$ -Parameter-based RF Device Characterization

Multiport Network S-parameter Restoration and Calibration with 2-Port Network Analyzer

A Low Complexity Approach for Calibration and Characterization of a Millimeter Wave Phased-Array Transceiver-Antenna Module

In-Situ Calibration of Antenna Arrays for Positioning With 5G Networks

Experimental Performance Evaluation of Cell-free Massive MIMO Systems Using COTS RRU with OTA Reciprocity Calibration and Phase Synchronization.

In Situ Calibration of Antenna Arrays for Positioning With 5G Networks

Design of Coupler-Switch Network and Interference Cancellation Scheme for Highly Scalable Self-Calibration Beamforming Systems

Adaptor Calibration Using A Matched Load And An Adjustable Shorter Without Specified Phases

Multiprobe-Enabled Over-the-Air Calibration of Millimeter-Wave Antenna Arrays: Concepts and experimental validations

An Ultrawideband Asymmetric Calibration Method for a Simultaneously Electromagnetic Near-Field Probing System

A New Method Based on the Construction of Hypothetical Symmetrical Networks for Fixture Calibration in Network Analyzers

A Self-Calibration Method for 5G Full-Digital TDD Beamforming Systems Using an Embedded Transmission Line