Abstract:Calibration is essential to optimize the performance of any radio transceiver during its development and manufacturing processes. This paper proposes over-the-air (OTA) calibration methods based on measuring and calibrating the phases of phased array transceiver paths. The phase responses of each signal path with all phase shifter states were characterized using an OTA radio link in the transmission and reception modes. Scattering parameter measurements give amplitude and phase responses over the frequency range, which can be converted to the delay domain with the Fourier transform. In this paper, two new delay domain phase calibration methods are presented and compared with a previously presented frequency domain method. The best performance was achieved with the relative phase calibration method in the delay domain which uses all measurement data to find the calibration values. The other two methods, i.e., the absolute phase calibration method in the delay domain and in the frequency domain, use the average phase as the calibration value. OTA radiation pattern measurements from two prototype 5G millimeter wave transceivers were used to compare the RF performances of the calibration methods, and measurements were performed with a 100 MHz 5G new radio waveform. The radiation patterns were analyzed based on direction accuracy, power level, and side lobe level, to give a few examples. The transceiver units were calibrated using the three studied methods, and while having significantly different uncalibrated performances, after calibration, both transceivers were tuned to similar performance levels.

A Low Complexity Approach for Calibration and Characterization of a Millimeter Wave Phased-Array Transceiver-Antenna Module

A Frequency-Domain I/Q Imbalance Calibration Algorithm for Wideband Direct Conversion Receivers Using Low-Cost Compensator.

MMIC on-Wafer Test Method Based on Hybrid Balanced and Unbalanced RF Pad Structures

Digitally Assisted IIP2 Calibration for CMOS Direct-Conversion Receivers

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

Calibration of a Digital Phased Array by Using NCO Phase Increasing Algorithm

A Blind Calibration Model for I/Q Imbalances of Wideband Zero-IF Receivers

Low-Complexity Calibration Of Joint Tx/Rx I/Q Imbalance In Wideband Direct-Conversion Transceiver

A Simple Over-The-Air Hardware Calibration Procedure In Tdd Systems

A Hybrid Scheme for TX I/Q Imbalance Self-Calibration in a Direct-Conversion Transceiver

I/Q imbalance calibration based on simulated annealing algorithm

Multiprobe-Enabled Over-the-Air Calibration of Millimeter-Wave Antenna Arrays: Concepts and experimental validations

Fast Antenna Array Calibration Using One External Receiver

A Hybrid Approach To I/Q Imbalance Self-Calibration In Reconfigurable Low-If Receivers

Over-the-Air Phase Calibration Methods for 5G mmW Antenna Array Transceivers

Board-level Code-Modulated Embedded Test and Calibration of an X-band Phased-Array Transceiver

An In-Situ Self-Test and Self-Calibration Technique Utilizing Antenna Mutual Coupling for 5G Multi-Beam TRX Phased Arrays

Over-the-Air Antenna Array Calibration for mmWave Hybrid Beamforming Systems Based on Monte Carlo Markov Chain Method

An Efficient Calibration Algorithm for IRS-Aided Mmwave Systems with Hardware Impairments.

A new method to simultaneously estimate TX/RX IQ imbalance and channel for OFDM systems

A Sensing-Based Over-the-Air Phased Array Antennas Phase Calibration Method With Greedy Algorithm