Abstract:This work presents a 14-bit 500 MS/s single-channel pipelined-successive-approximation-register (SAR) analog-to-digital converter (ADC) with an adaptively biased floating inverter amplifier (AB-FIA) as the residue amplifier (RA) and a hybrid reference ripple mitigation (H-RRM) technique to relax the power and area burden on the reference stabilization. Leveraging the adaptively biased architecture in the last stage FIA, the speed and open-loop gain of the proposed two-stage FIA are enhanced compared with the conventional cascode counterpart. Besides, the impact of the reference error on the pipelined-SAR conversion accuracy is alleviated by hybridizing the improved reference ripple cancellation (RRC), reference ripple neutralization (RRN), and reference buffer (RBUF). The improved RRC removes the potential noise coupled from the floating capacitor to counter the decision error during the sub-SAR conversion in the first stage. Meanwhile, the RRN facilitates a rapid reference recovery. These acts constitute the H-RRM, which assists a high-speed and high-resolution pipelined-SAR process with a relaxed integrated reference RBUF with low-power and compact area. The prototype ADC was fabricated in a 28 nm CMOS process; it consumes 6.34 mW total power at 500 MS/s, including 2.4 mW dynamic power of RBUF. It occupies an active area of 0.018 mm $^{2}$ , which the ADC core area of 0.0168 mm $^{2}$ and the area of RBUF with a 2.3 pF decoupling capacitor is 0.00105 mm $^{2}$ . The measured signal to noise and distortion ratio (SNDR) and spurious free dynamic range (SFDR) are 64.2 dB and 80.55 dB with a Nyquist input, respectively, leading to a 170.2 dB Schreier figure-of-merit (FoM) (FoM $_{\mathrm{S}}$ ) and 9.6 fJ/conversion-step Walden FoM (FoM $_{\mathrm{W}}$ ).

A 12bit 160ms/s Pipelined SAR ADC with a MOS Self-Biased Cascoded Ring Amplifier

A 16-Bit 2.5-Ms/s SAR ADC with On-Chip Foreground Calibration

A 14-Bit 500-Ms/s Pipelined-SAR ADC in 28-Nm CMOS with Foreground and Background Calibration

Design of an 8-Channel 12bits 1MSPS SAR ADC

A 12-Bit 2.32gs/s Pipelined/sar Hybrid ADC with a High-Linearity Input Buffer.

A 12-Bit 1.5-Gs/s Single-Channel Pipelined SAR ADC with a Pipelined Residue Amplification Stage

A 800 MS/s, 12-Bit, Ringamp-Based SAR Assisted Pipeline ADC with Gain Error Cancellation

A 625ms/s, 12-Bit, SAR Assisted Pipeline ADC with Effective Gain Analysis for Inter-stage Ringamps

A 200ms/s, 11 Bit SAR-assisted Pipeline ADC with Bias-Enhanced Ring Amplifier.

A 12-bit 100-MSps pipelined-SAR ADC with a time-interleaved second-stage

A 0.004-Mm2 200-Ms/s Pipelined SAR ADC with Kt/c Noise Cancellation and Robust Ring-Amp

A 13-Bit 312.5-Ms/s Pipelined SAR ADC with Open-Loop Integrator-Based Residue Amplifier and Gain-Stabilized Integration Time Generation

A 71.5-Db SNDR 475-Ms/s Ringamp-Based Pipelined SAR ADC with On-Chip Bit-Weight Calibration

9.1 A 2mW 70.7dB SNDR 200MS/s Pipelined-SAR ADC with Continuous-Time SAR-Assisted Detect-and-Skip and Open-then-Close Correlated Level Shifting.

A Time-Interleaved SAR Assisted Pipeline ADC with a Bias-Enhanced Ring Amplifier.

A 10mw 10-ENOB 1gs/s Ring-Amp-Based Pipelined TI-SAR ADC with Split MDAC and Switched Reference Decoupling Capacitor.

A 2.5-Gs/s Four-Way-Interleaved Ringamp-Based Pipelined-SAR ADC with Digital Background Calibration in 28-Nm CMOS

A 0.004mm2 200MS/S Pipelined SAR ADC with Kt/c Noise Cancellation and Robust Ring-Amp

A 14bit 320MS/s pipelined-SAR ADC based on multiplexing of dynamic amplifier

A 14b 500 MS/s Single-Channel Pipelined-SAR ADC With Reference Ripple Mitigation Techniques and Adaptively Biased Floating Inverter Amplifier

A 10-Bit 500-Ms/s Pipelined SAR ADC with Nonlinearity-Compensated Open-loop Amplifier and Parallel Conversion Through Comparator Reusing