Abstract:Nitrogen oxides (NOxs) are some of the most important hazardous air pollutants from industry. In China, the annual NOx emission in the waste gas of industrial sources is about 8.957 million tons, while power plants remain the largest anthropogenic source of NOx emissions, and the precise control of NOx in power plants is crucial. However, due to inherent issues with measurement and pipelines in coal-fired power plants, there is typically a delay of about three minutes in NOx measurements, bringing mismatch between its control and measurement. Measuring delays in NOx from power plants can lead to excessive ammonia injection or failure to meet environmental standards for NOx emissions. To address the issue of NOx measurement delays, this study introduced a hybrid boosting model suitable for on-site implementation. The model could serve as a feedforward signal in SCR control, compensating for NOx measurement delays and enabling precise ammonia injection for accurate denitrification in power plants. The model combines generation mechanism and data-driven approaches, enhancing its prediction accuracy through the categorization of time-series data into linear, nonlinear, and exogenous regression components. In this study, a time-based method was proposed for analyzing the correlations between variables in denitration systems and NOx concentrations. This study also introduced a new evaluation indicator, part of R2 (PR2), which focused on the prediction effect at turning points. Finally, the proposed model was applied to actual data from a 330 MW power plant, showing excellent predictive accuracy, particularly for one-minute forecasts. For 3 min prediction, compared to predictions made by ARIMA, the R-squared (R2) and PR2 were increased by 3.6% and 30.6%, respectively, and the mean absolute error (MAE) and mean absolute percentage error (MAPE) were decreased by 9.4% and 9.1%, respectively. These results confirmed the accuracy and applicability of the integrated model for on-site implementation as a 3 min advanced prediction soft sensor in power plants.

Economic Generalized Predictive Control of Denitration System in Thermal Power Plant

Sustainable Integration of Stream Power Plant Couple of Contaminant Emissions Reduction Technology

Predictive Control and Economic Performance Optimization of CFBB Combustion Process

Load Optimal Distribution for Power Plants with Consideration of Environmental Costs

Model Predictive Control Case Study: Selective Catalytic Reduction (scr) System in Coal-Fired Power Plant

Advanced Exergoenvironmental Evaluation for a Coal-Fired Power Plant of Near-Zero Air Pollutant Emission

Fuzzy Adaptive Generalized Predictive Control for Wastewater Treatment Process

Predictive control of SCR denitrification system in thermal power plants based on GA‐BP and PSO

Multi-index control strategy from cement calcination denitration system: a model predictive control method for combined control of nitrogen oxide and ammonia escape

An active disturbance rejection stair-like generalized predictive control with time delay weakening for denitrification process in thermal power unit

The Integrated System Optimization Based on the Boiler Combustion and Denitration with Denitration Operating Cost Consideration.

Research on Optimization of Flow Field of Denitration System of 600MW Unit and Modification of Fine Ammonia Injection

Multi‐model predictive control of SCR flue gas denitrification system in coal‐fired power plant based on kernel fuzzy c‐means clustering and integrated model

Application of an Improved State Feedback Control in the Selective Catalytic Reduction Denitrification Systems of Coal Power Units Under Variable Load Conditions

Enhancement of SCR denitrification control strategy considering fluegas temperature fluctuation: Fundamental principle and performance evaluation

Intelligent ammonia injection control system suitable for full load

Two-timescale Nonlinear Model Predictive Control for Flexible Operation of Coal-Fired Power Plant with Post Combustion CO2 2 Capture System

Development of a Real-Time NOx Prediction Soft Sensor Algorithm for Power Plants Based on a Hybrid Boost Integration Model

Environmental Economic Dispatch Towards Multiple Emissions Control Coordination Considering A Variety Of Clean Generation Technologies

Prediction and Control of the Nitrogen Oxides Emission for Environmental Protection Goal Based on Data-Driven Model in the SCR De-Nox System

Multi-objective performance optimization and control for gas turbine Part-load operation Energy-saving and NOx emission reduction